Connecting An Audio Device; Handsfree Talk; Receiving Calls; Making Calls - Sony MEX-BT2500 Manual De Instrucciones

Connecting the last-connected
cellular phone from this unit
1 Be sure that both this unit and the cellular
phone are switched to Bluetooth signal on.
2 Press (SOURCE) repeatedly until "BT
PHONE" appears.
3 Press (handsfree).
" " flashes while the connection is being
made. And then "
connection is made.
Note
While streaming Bluetooth audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead. A connecting noise
may be heard over playback sound.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification. If
this unit does not reconnect automatically, connect
manually.

Connecting an audio device

1
Be sure that both this unit and the
audio device are switched to
Bluetooth signal on.
2
Connect to this unit using the audio
device.
" " appears when the connection is made.
Connecting the last-connected audio
device from this unit
1 Be sure that both this unit and the audio device
are switched to Bluetooth signal on.
2 Press (SOURCE) repeatedly until "BT
AUDIO" appears.
3 Press (6).
" " flashes while the connection is being
made. And then "
connection is made.
" stays lit when the
" stays lit when the

Handsfree talk

Receiving calls

When receiving a call, a ring tone is output from
your car speakers. Check that the unit and
cellular phone are connected beforehand.
1
Press (handsfree) when a call is
received with a ring tone.
The phone call starts.
To end a call
Press (handsfree) again.
To reject an incoming call, press and hold
(handsfree) for 2 seconds.
Note
The microphone of this unit is located on the rear of
the front panel (page 9). Do not cover the microphone
with tape, etc.

Making calls

In the case of making calls from this unit, only
redial is used.
1
Press (SOURCE) repeatedly until "BT
PHONE" appears.
2
Press and hold
seconds or more.
The phone call starts.
To end a call
Press (handsfree) again.
To call another phone, use your cellular phone,
and then transfer the call.
For call transfer details, check the following.

Call transfer

In order to activate/deactivate the appropriate
device (this unit/cellular phone), check the
following.
1
Press and hold
your cellular phone.
For details on cellular phone operation, refer to
your cellular phone manual.
Note
Depending on the cellular phone, handsfree
connection may be cut off when call transfer is
attempted.
(handsfree) for 3
(handsfree) or use
13