Metria M51 Manual De Instrucciones página 5

METRIA M51 Benchtop Conductivity/TDS Meter
Installing the Electrode Holder
Take out the electrode arm from the packaging. The base plate of the electrode holder has a circular hole, the electrode arm has a
connecting rod. Insert the connecting rod into the circular hole and swivel the electrode arm 90
into desired position.
Adjustment of electrode arm
After installation, if the electrode arm automatically rises or falls, you need to adjust the screws until arm locate at any position.
1. Remove the plastic cover from the electrode arm.
2. Use the screwdriver to tighten the screw moderately.
3. Insert the plastic cover to previous position. Installation is completed.
Connecting the Electrode
1. Take out the conductivity electrode from the packaging. Follow the steps below to place the electrode into left or right side of the
electrode arm.
1. Insert the
electrode
2. Hook up the cable
3. Hook up the cable
o
. Electrode holder is now ready to swing
4