Temperature Compensation - Metria M51 Manual De Instrucciones

METRIA M51 Benchtop Conductivity/TDS Meter

Temperature Compensation

For better accuracy, we recommend the use of either a sensor with a built-in or a separate temperature probe for the calibration or
measurements.
Automatic Temperature Compensation
Connect the temperature probe to the meter (Refer to page 5 "Connecting the Temperature Probe"). The ATC icon immediately appears on
the display, the meter is now switched to the automatic temperature compensation mode.
Manual Temperature Compensation
If the meter does not detect a temperature probe, the °C icon will show on the display indicating that the meter is switched to the manual
temperature compensation mode. To set the temperature value of sample, follow the steps below.
1. Press the o key to enter the temperature setting mode.
C
Press the  or  key to modify the temperature value.
2.
3. Press the key to confirm.
Enter

Press the  or  key once, the setting value will increase or decrease by 0.1. Press and hold the  or  key, the setting value will
increase or decrease by 1.
8