Kärcher IVM 60/30 M Z22 Manual Del Usuario página 15

WARNING
Safety equipment for preventing hazards must be ser-
viced and maintained regularly. This means that the
manufacturer's staff or persons trained by the manufac-
turer must check the equipment for proper functioning at
least once a year, i.e. check for leaks, filter damage,
functioning of the controlling elements, etc.
ATTENTION
Risk of damage! Do not use detergents containing sili-
cone to clean.
– No outside help is required for carrying out basic
maintenance and cleaning.
– The appliance surface and the inside of the con-
tainer should be cleaned regularly using a damp
cloth.
DANGER
Risk due to dust hazardous to health. Always use dis-
posal clothing and P2 or higher breath-safe masks while
carrying out maintenance tasks (such as changing fil-
ters).
Inspection and maintenance work
Have the vacuum cleaner regularly inspected according
to the respective national accident prevention regula-
tions.
Maintenance work must be carried out by a specialist at
regular intervals in accordance with the specifications of
the manufacturer. The existing stipulations and safety
requirements are to be here observed. Work on the
electrical plant may only be carried out by qualified elec-
tricians.
If you have any more questions, your KÄRCHER
branch will be happy to help.
Maintenance intervals / user maintenance
No periodic maintenance intervals are specified for this
device. The following maintenance is to be performed
as necessary:
 Wash the filter.
 Change the filter.
 Replace the filter.
Wash the filter
The filter can be washed out under running water.
Always flush the filter from the inside to the outside so
that no remaining particles impair the filter capacity.
ATTENTION
Risk of damage! Do not use washing agents or bleach.
Changing/ replacing filter
Note: 2 persons are required to remove the suction
head.
 Switch off the appliance and disconnect from the
network.
 Release and remove the suction head.
 Unlock and remove the spacer.
 Take out the filter.
 Dispose of used filter in dust-tight bag in accord-
ance with statutory regulations.
 Remove the dirt that has accumulated on the pure
air side.
 Check sealing ring for damage.
 Pull the new filter over the filter vibrator on the
spacer such that the vibrating elements are aligned
centrally in the filter bags. Then place both parts to-
gether onto the filter ring and lock the spacer.
 Insert and lock the suction head.
DANGER
Risk of explosion! The electrostatic earthing between
chassis and dirt container via the spring bow must be
ensured.
Replace the disposal bag
 Lock parking brakes.
Illustration
 Unplug the pressure equalizer at the lower end.
 Pull the handle of the container upwards. The con-
tainer is unlocked and lowered.
 Switch on device to avoid releasing dangerous
dusts.
 Pull the container out by the handle.
Illustration
 Put the disposal bag over.
 Tightly close disposal bag by means of the closing
strip.
 Remove disposal bag.
 Dispose of the disposal bag according to the local
provisions.
Illustration
 Insert the new disposal bag so that it is snug
against the reservoir wall and the reservoir bottom.
 Pull disposal bag over the container.
DANGER
Risk of explosion! The electrostatic earthing between
chassis and dirt container via the spring bow must be
ensured.
 Reinsert the container.
 Turn off the appliance.
 Push the handle of the container downwards. Con-
tainer is locked
WARNING
Risk of crushing! Watch out for moving parts when re-
moving and replacing the container.
 Plug in the pressure balancing.
Troubleshooting
DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
DANGER
Have all checks and work on electrical parts performed
by an expert. If malfunctions continue, please contact
the Kärcher Customer Service.
Note: In case of a failure (e.g. filter breakage) the appli-
ance must be turned off immediately. The failure must
be remedied before the appliance is put into operation
again.
Suction turbine does not run
 Check the receptacle and the fuse of the power
supply.
 Check the power cable and the power plug of the
device.
 Turn on the appliance.
Suction capacity decreases
 Remove choking of suction nozzle, suction tube or
suction hose.
 Replace the filled disposal bag
 Check the suction head and the receptacle for
proper seating.
 Clean filter.
 Empty the container.
 Connect the pressure balancing at both ends.
– 5
EN 15