Slime Pro Power Manual página 4

TROUBLESHOOTING
Inflator does not turn on:
1. Check the fuse. It may have blown: 12V fuse is located
in the plug adapter.
2. Unscrew the tip, remove fuse, and inspect. If necessary,
replace fuse with 15A, 250V (5mm×20mm).
3. Check vehicle's power outlet fuse; it should be a minimum of 15 amps.
4. Check receptacle and plug terminals for dirt (particularly tobacco). Use a non-conductive
probe (not fingers or metal) to dislodge and remove debris.
5. Push the power plug firmly into the receptacle and twist it back and forth.
Inflator runs but does not inflate:
1. Be sure the air hose connector is tightly screwed onto the valve stem.
2. Check tire for leaks. Check hose for breaks and leaks at fittings.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for
25 minutes.
2. The voltage may be too low. Check the condition of your vehicle's battery.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim
allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary
to jack up the tire prior to inflation.
FOR WARRANTY INFORMATION GO TO: www.slime.com/warranty
QUESTIONS OR COMMENTS: Call (888)457-5463 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime® is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.