Fcc Statement - Aastra DT390 Guía De Referencia Rápida

FCC Statement

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
--------------------------------------------------------------
Privacy of communications may not be ensured when
using this phone.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
device complies with FCC SAR limit of 1.6 W/kg. The
maximum SAR value measured when used at the ear
is 0.043 W/kg. This device must not be colocated or
operating in conjunction with any other antenna or
transmitter.
• This equipment complies with Part 68 of the FCC
rules and the requirements adopted by the ACTA. On
the rear side, underneath the battery of this equipment
is a label that contains, among other information, a
product identifier in the format US:AAAEQ##TXXXX.
If requested, this number must be provided to the
telephone company.
All manuals and user guides at all-guides.com
• REN is N/A as this product is intended to be
connected behind a FCC Part 68 compliant PBX
system. It is not intended for direct connection to
telephone network.
• If this equipment cause harm to the telephone
network, the telephone company will notify you in
advance that temporary discontinuance of service may
be required. But if advance notice isn't practical, the
telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
• The telephone company may make changes in its
facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this
happens, the telephone company will provide advance
notice in order for you to make necessary modifica-
tions to maintain uninterrupted service.
• If trouble is experienced with this equipment, for
repair or warranty information, please contact your
Aastra business partner http://www.aastra.com.
This equipment is not intended to be repaired by the
customer (user). If the equipment is causing harm to
the telephone network, the telephone company may
request that you disconnect the equipment until the
problem is resolved.
• Connection to party line service is subject to state
tariffs. Contact the state public utility commission,
public service commission or corporation commission
for information.
• If your home has specially wired alarm equipment
connected to the telephone line, ensure the installation
of this equipment that it does not disable your alarm
equipment. If you have questions about what will
disable alarm equipment, consult your telephone
company or qualified installer.
Electrical Safety Advisory
Electrical surges, typically lightning transients, are very
destructive to customer terminal equipment connec-
ted to AC power sources. Customer is thus recom-
mended to use a surge arrestor for the equipment that
requires AC power.
5