Safety Device - Lavorwash MAJOR Manual De Instrucciones

EN
replacing spare parts
• XJ WARNING: If an extension cord is used,
the plug and socket must be of watertight
construction.
•WARNING: It is absolutely forbidden to
use the machine in potentially explosive
environments or areas.
• WARNING:
- NEVER EVER TOUCH THE MACHINE WITH
WET HANDS OR BARE FEET.
- NEVER PULL THE POWER SUPPLY CABLE OR
MACHINE IN ORDER TO DISCONNECT THE
PLUG FROM THE SOCKET.
- IF DURING FUNCTIONING THE POWER
SUPPLY RUNS OUT, FOR SAFETY REASONS,
TURN THE MACHINE OFF.
• K1 All the maintenance and adjustment
activities described in this handbook must
be carried out only after stopping the ma-
chine (main switch turned to off) and discon-
necting the power cord, if not clearly indica-
ted that the operation must be carried out
when the machine is on.
• K2
All the adjustment and activities that
are not described in this handbook must be
carried out by qualified and skilled operators
to avoid any accident or damage to the ma-
chine and to the operator.
• K3 Carefully read this operating handbook
before use.
It provides important information about a
safe installation, use and maintenance of the
machine.
• K4
The non-compliance with the safety
measures may entail serious injuries to the
operator and damages to the machine.
• K5 Carefully keep this handbook for con-
sultation purposes up to the machine final
dismantling. The use and maintenance ac-
tivities must be carried out correctly; other-
wise, the builder cannot be held responsible
for the damages to people, animals or things
deriving from the non-compliance with the
following instructions.
• K6 Check that both the machine and its
components are undamaged when unpa-
cking them. Contact your reseller in case of
doubts.
• K7 Make sure that the rating correspon-
ds to the factory power line before energi-
sing the machine.
• K8 De-energise the machine before any
cleaning or maintenance activity.
• K9 Never leave the machine energised if
unused. Turn the main switch off.
• K10De-energise the machine in case of fai-
lure and / or troubles. Do not tamper with
its controls and equipment. Just contact the
authorised after-sales service points for ser-
vicing purposes and always order original
spare parts.
• K11 The draining and loading pipes, the
safety sheaths and the solenoid valves must
not be cut and tampered with. De-energise
the machine in case of damages
• K12 Any use of the machine other than
the one it has been built for represents an
anomalous condition and can cause serious
damages to the operating means and entail
a serious risk for the operator using it.
• K13 Never remove or hide the warning la-
bels applied to the machine.
• K14 The same instructions are valid for
various models; some details may differ ac-
cording to the machine model.
• K15 Never touch or start the machine
with wet hands or bare feet;
• K16 Remove the casings and the doors of
the electric boards only once the machine
has been stopped and de-energised;
For fire-prevention purposes:
• K18
Keep all inflammable or combustible
products away from the equipment area.
• K19
Obviously,
instructions are not sufficient to prevent all
sorts of accidents; therefore, the user will
have to be cautious.
• K20 The machine must not be modified or
changed in any way without the builder's
written authorisation.
• WARNING: We recommend the use of de-
mineralized water.
• WARNING: Never use the power cable or
the gun cable to move it.
> SAFETY DEVICE
• WARNING: the gun is fitted with a safety
catch. Whenever use of the machine is
interrupted it is important to operate the
safety catch to prevent accidental activation
of the jet.
18
the above-mentioned