Jonsered 500 M Manual Del Operador página 11

All manuals and user guides at all-guides.com
Always handle the blade with care - sharp
edges could cause injury.
USE GLOVES
Renew your metal blade after 50 hours
mowing or 2 years whichever is the sooner
- regardless of condition.
If the blade is cracked or damaged replace
it with a new one.
ANNUALLY CARRY OUT THE FOLLOWING:
1. Sharpening and balancing the cutter blade.
Remove the spark plug lead. Remove the
cutter blade and take it to a service
workshop for sharpening and balancing.
When reassembling the blade ensure that
the retaining washer is flat and not dished,
tighten the bolt to a torque of 35-40 Nm. (N)
2. Change the oil after each season or after 25
hours. Run the engine until warm.
Remove the spark plug lead. Remove the
blade to gain access to the oil drain plug,
open the drain plug underneath the mower
and let the oil run out. Refit the plug and fill
with new oil, SAE 30. (P)
3. The engine brake cable should always be
adjusted to stop the engine within 3 sec.
CAUTION! For adjustment contact your
authorized service dealer. (Q1 - Briggs &
Stratton), (Q2 - Tecumseh)
4. Remove cover and take out the air filter.
(R1 & R2 - Briggs & Stratton), (R3 -
Tecumseh)
5. Clean the filter with warm, soapy water and
dry thoroughly. Add 2-3 spoons of oil,
distributing evenly throughout the filter.
Transport
Remove the spark plug lead
Loosen the wire/cable from the handle before
carefully folding it.
Avoid damaging the wire/cable
Empty the petrol tank.
The machine must be drained of oil and fuel
when moving it by public transport.
MAINTENANCE
N
Q1
Br. & Str.
R1
Br. & Str.
Service
When ordering spare parts, always quote the
mower's product number. Always check oil
level after service.
Annually
P
Q2
Tecumseh
R2
Br. & Str.
R3
Tecumseh
6 - ENGLISH