Installation Instructions; Tools Required - TEKONSHA PRODIGY iD Manual De Instrucciones Y Operación

Components of PRODIGY iD
A. Power Module E. Knob Base
B. Dash Module F. Mounting Collar
G. Red Cap
C. Manual Knob
H. Universal Wire Harness
D. LED Display
A
E
D
C
Determine Mounting Location
Dash Module and Display Assembly
WARNING
The Prodigy iD Dash Module and Display must be
securely mounted to the vehicle. Failure to install the Dash Module
and Display within the specified constraints may cause impaired
performance.
WARNING To prevent SERIOUS INJURY, DEATH or DAMAGE to
vehicle, make sure area behind the dash panel is clear before drill-
ing. Minimum required space for installation is approximately 2.32in
(59mm) tall, by 2.17in (55mm) wide, and 2.68in (68mm) deep.
WARNING
Correct orientation and mounting of the Dash
Control and Display is required for proper operation. The Dash
Control and Display must be securely mounted to a solid surface.
CAUTION Do not remove red cap until after the Dash Module
has been mounted.
NOTE: The Dash Module connects to the Power Module with the
included harness. Consider the location of both modules relative to
each other and verify harness routing before drilling any holes.
I. Hardware Kit
J. Drill Template
B
G
F
C
H
I
- 4 en -
- 6 en -

Installation Instructions

WARNING
tools required for the installation, stop the installation and contact a
professional installer.

Tools Required

A. Drill motor
B. Drill bit: 7/32"
C. Hole saw: 1"
D. Center punch
E. Allen/hex wrench: 1.5mm
A
B
TOP
A
(7/32")
(7/32")
C
D
(7/32")
B E
(7/32")
(1")
J
Dash Module Mounting Orientation Considerations
The Prodigy iD must
be parallel to direc-
tion of travel (±20
degrees), see below.
Top View
+20º
Direction of Travel
If you need additional assistance or do not have the
F. Wire cutters
G. Crimp tool
H. Voltage Tester
I. Panel removal tools
F
D E
I
- 5 en -
Front of the Prodigy
iD must be horizontal
(±20 degrees), see
below.
Front View
+20º
-20º
-20º
- 7 en -
G
H
The Prodigy iD can
be mounted from 0
to 360 degrees, in
the direction of travel,
see below.
Side View
Direction of Travel