TEKONSHA PRODIGY iD Manual De Instrucciones Y Operación página 3

Automatic Leveling of the Sensor
The Prodigy iD will automatically acquire the proper level setting. It
will also automatically adjust as you travel up or down hills.
Determine a suitable mounting location for the Dash Module. The
Dash Module can mount in vehicle panels up to 0.17in (5.0mm) thick.
It must be within a maximum angle relative to the forward direction of
vehicle travel for the inertia sensor to work correctly and for the driver
to access the Manual Override and Dash Module (manual braking).
For easy of installation, temporarily remove panel for drilling and
mounting. Place Drill Template on panel at desired Dash Module
mounting location and mark each drill point with the center punch.
CAUTION To ensure alignment of the display, confirm horizontal
center line alignment, then drill holes sized as
indicated, and in the alphabetical order shown.
Drill Template may optionally be removed
from panel prior to drilling if holes are
marked properly. A scale copy of the
Drill Template is included in this booklet
as a backup and for reference.
With Mounting Collar inserted in panel, free the
Clamp Wings by loosening (counter-clockwise)
screws one-half turn with the 1.5mm hex key.
Once free, clamp the Mounting Collar to the
panel by hand tightening screws clockwise. This
will clamp the Mounting Collar to the panel.
Ensure the assembly is secured to the panel and
that both Clamp Wings are hand tight.
WARNING Do not over tighten. Failure to properly tighten the
Mounting Collar screws could cause improper/reduced performance,
excessive road noise, and even damage the device.
CAUTION
Do not remove
red cap until after Dash Module
is firmly secured to the panel.
WARNING Verify assembly
orientation.
Snap Rear Switch Assembly into
Mounting Collar.
TOP
C
(7/32")
B
(7/32")
- 8 en -
- 10 en -
Dash Module Assembly
IMPORTANT Using Mounting Collar assembly, ensure fit and clear-
ance with drilled panel holes. Trim as necessary to ensure perimeter of
Mounting Collar can sit flush to mounting panel before continuing.
Verify that Mounting Collar has its aluminum "Clamp Wings" locked
in the inward position and insert into the drilled hole with Indicator
Arrow on the outside point up to the "12 o'clock position"
A
(7/32")
D
(7/32")
E
(1")
Insert and tighten Screws to secure the Dash Module to the Mounting
Collar. Verify that screw heads are flush and entire assembly is secured
to the dashboard.
WARNING
panel and in final mounting location.
Align Knob Base as shown with Indicator Arrow pointing up in the
"12 o'clock" position and press straight inward until all three snap fits
engage. When properly assembled, Knob Base should be able to turn
evenly with a spring return. Remove the red anti-static cap.
CAUTION
Clamp Wings
inward postion
- 9 en -
Hand tighten only. Verify assembly is firmly secured to
DO NOT TOUCH THE ELECTRICAL CONTACTS.
- 11 en -
Arrow up in
12 o'clock
position
Behind
Vehicle Dash