Menu Button - TEKONSHA PRODIGY iD Manual De Instrucciones Y Operación

Power Module Wiring
OPTION 1:
Universal Wire Harness Installation
WARNING Reversing BLACK and WHITE wires, or improper
wiring will damage or destroy the brake control.
Be sure to solidly connect all four wires or brake control will not
function properly.
Use of proper gauge wire when installing the brake control is
CRITICAL; smaller gauge wire may result in less than efficient braking.
Minimum wire gauges are as follows:
• 1-2 axle applications – 14 AWG.
• 3-4 axle applications – 12 AWG.
1. The brake control must be installed with a 12 volt negative ground
system.
2. Soldering is recommended or crimp-on butt connectors are a
suitable substitution.
3. Route all wires as far from the radio antenna as possible to reduce
AM interference.
4. Collection of water inside the trailer connector mounted on the tow
Tekonsha Edge Mobile App
™
ONCE YOUR PRODUCT IS INSTALLED:
WARNING DO NOT USE TEKONSHA EDGE
UNE FOIS QUE VOTRE PRODUIT EST INSTALLÉ
ONCE YOUR PRODUCT IS INSTALLED:
UNA VEZ EL PRODUCTO ESTÉ INSTALADO:
DOWNLOAD TEKONSHA EDGE
DOWNLOAD TEKONSHA EDGE
TÉLÉCHARGEZ L'APPLICATION TEKONSHA EDGE™ - APPLE STORE, GOOGLE PLAY
DESCARGUE LA APLICACIÓN TEKONSHA EDGETM EN APPLE STORE, GOOGLE PLAY
CREATE ACCOUNT
CREATE ACCOUNT
CRÉEZ UN COMPTE
CREE UNA CUENTA
GET IN RANGE OF BRAKE CONTROL
GET IN RANGE OF BRAKE CONTROL
PLACEZ-VOUS À PORTÉE DE LA COMMANDE DE FREIN
UBÍQUESE DENTRO DEL ÁREA DE ALCANCE DEL CONTROL DE FRENOS
FOLLOW DIRECTIONS ON APP SCREEN
FOLLOW DIRECTIONS ON APP SCREEN
SUIVEZ LES INDICATIONS À L'ÉCRAN DE L'APPLICATION
SIGA LAS INSTRUCCIONES EN LA PANTALLA DE LA APLICACIÓN
- 16 en -
APP WHILE DRIVING.
™
APP
™
APP
™
- 18 en -
vehicle will reduce the life of the connector.
5. Use the Universal Harness and splice the wires into the function
wires as shown on the Wiring Diagram.
Wiring Legend
BLACK Wire (Positive Battery, 12VDC)
WHITE Wire (Negative Battery, Chassis Ground)
RED Wire (cold side of stoplight switch)
BLUE Wire (brake output to trailer)
OPTION 2:
Plug & Play Wire Harness (Sold Separately)
If your vehicle comes equipped with a factory tow package, brake
control function wires with a connector may exist under the
vehicle dash. Consult the vehicle manual or call for the location of
the harness. A vehicle specific Plug & Play harness may be purchased
separately. For easy installation simply plug the vehicle specific
connector into the factory tow package harness and plug the other
end directly into the Plug & Play Harness on the brake control.
Operating Instructions
Manual Override
The Manual Override is the rotary control knob. It allows the user to
apply the trailer brakes to the maximum power set by the user with the
Power Output setting.
When the Manual Override is rotated clockwise, the Brake Output
Voltage will override the proportional value. The Brake Output
Voltage will increase, starting at
as set by the Power Control setting.

Menu Button

The Menu Button is used to enter the Programming Menu and confirm
settings. When the Menu Button is held for longer than 5 seconds, the
display will change to the Programming Menu. Rotating the Manual
Override is used to change Menu selections and settings.
- 17 en -
and go to the Maximum value
- 19 en -