Warning! Safety Instructions; Important Set Up Information - Marshall 1987X Manual Del Usuario

ENGLISH

WARNING! SAFETY INSTRUCTIONS

Please read this manual carefully before plugging in. Follow all instructions and heed all
warnings.
Warning: please refer to full details in separate
Important Safety Instructions leaflet
(document number CATS-00158).
MAINS ELECTRICITY SUPPLY AND OUTPUT
IMPEDANCE
Your amp can be used with any one of three
different mains electricity supply settings: 110V,
220V or 230V. You should set the mains selector
in accordance with your mains electricity supply.
Also check the value and type of mains fuse
fitted.
For each of the settings above, the correct value
and type of mains fuse is specified on the rear
panel of your amp. Never attempt to bypass any
fuse or fit one of the incorrect value or type.
The output impedance selector should be set
to the total impedance of the speaker cabinet(s)
(or load) being used.
If you have any doubt regarding your mains
electricity supply or the impedance of speaker
cabinet(s), please seek help from a qualified
engineer – your Marshall dealer can help you
with this.
Warning: your amp must be switched off and
disconnected from the mains electricity supply
before you:
• change the mains selector for a different
setting; and/or
• check and/or change any fuse; and/or
• change the output selector for a different
setting.
Failure to comply with any of the points above
may damage your amp.
2

IMPORTANT SET UP INFORMATION

1. Set the output impedance selector to the
impedance of the combined load of the
speaker cabinet(s) you will be using.
2. Connect one or two speaker cabinets to the
speaker outputs.
Warning: failure to do the above may damage
your amp. When connecting a speaker cabinet
make sure that you use a proper speaker cable.
Never use a screened (shielded) guitar cable for
this purpose.
3. Ensure that both the power switch and
standby switch are set to the off position.
4. Connect the supplied mains (power) lead
into the power inlet on the rear panel first
and then into an electricity outlet.
5. Ensure that any master, volume and/or
output level controls on the front panel are
set to zero.
6. Plug your guitar into one of the inputs on
the front panel.
7. Turn the power switch on and wait a couple
of minutes.
8. Turn the standby switch on.
9. Turn the volume up to your preferred level
and you're ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched off,
unplugged from the mains electricity supply and
all removable cables have been disconnected
from your equipment before attempting to
move it.
Only move the amp on its own. Do not attempt
to move it while it is stacked on top of a cabinet
or other equipment.