Start To Use - EAS ELECTRIC EMR44VNI1 Manual De Instrucciones

2.3 Placement
This wine cooler is built-in type, so it is recommended to keep 40 mm distance
at least from the back of the wine cooler to the interior back of outer cabinet,
and keep no obstruction in front of the air outlet. It is recommended that the
front levelling feet are 3mm higher than the rear levelling feet.
(This picture is only for
reference. The actual
configuration will
depend on the
physical product or
statement by the
distributor.)

2.4 Start to use

Before using the cooler, remove all packaging materials
including bottom cushions and foam pads and tapes
inside the cooler, tear off the protective film on the door
Avoid direct sunlight and heat sources such as stove,
The cooler is placed in a well-ventilated indoor place; the
ground shall be flat, and sturdy (rotate left or right to
adjust the feet for levelling if unstable).
 The cooler shall stay for half an hour before connecting power
when it is firstly started.
 Clean up the inner chamber before put into use for first time.
 Do not connect cooler to electronic energy saving plug and
converter that can convert DC into AC (E.g.: solar energy
system, ship grid).
 Water drop or frost will be generated on back side of wine
cooler when compressor is running, which is decided by
function of cooler. Wiping out frost or water drop is not
needed as the back will wipe them out automatically. The
defrosted water will be collected into drain tank, then inflow
into water disposal pan above the compressor and vaporized.
and the cooler body.
heating radiator, etc.
12 V.1