Philips FC6168 Información Importante página 8

ENGLISH
8
Problem
The appliance does
not work when I
push the button.
The vacuum cleaner
has a lower suction
power than usual.
Dust escapes from
the vacuum cleaner.
The brush does not
turn anymore.
All manuals and user guides at all-guides.com
Cause
The battery light flashes fast
because the batteries are low.
You cannot use the appliance
because the appliance is still
charging.
You have to press two buttons.
The filter and the cyclone are
dirty.
You have not connected the
dust bucket, the dust separator
and the cyclone properly.
Incorrect assembly of these
parts causes air leakage, which
leads to loss of suction power.
The filter is dirty.
The brush has encountered too
much resistance.
You switched on the appliance
by pressing the on button on
the handheld vacuum cleaner.
Solution
To charge the batteries, insert the small
plug into the socket on the appliance
and insert the adapter into a wall
socket.
You have to remove the small plug from
the socket on the appliance before you
can switch on the appliance.
First press the on/off button to switch
on the appliance. Then press the MAX
button to get maximum suction power.
Clean the filter and the cyclone.
Connect the dust bucket, the dust
separator and the cyclone properly.
Clean the filter.
Clean the brush.
Switch off the appliance by pressing the
on button on the handheld vacuum
cleaner again. Then switch it on again by
pressing the on button on the stick.