Página 1
All manuals and user guides at all-guides.com THT-210B/ S/ 1800 2000/ L/ 2100/ S 2120/ 240B 2510/ S/ 2520B/ S 2530/ 2540 HTD-2520PF/ 2522PF 2526PF/ 2530PF HTS-2530PF Owner's manual Manuel d'utilisation Manuale uso e manutenzione Bedienungsanleitung Manual del propietario Instruktionsbok...
Página 2
All manuals and user guides at all-guides.com WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. It is important that you read, fully understand and observe ATTENTION! the following safety precautions and warnings.
Página 3
All manuals and user guides at all-guides.com Before using your new unit Vor dem Gebrauch Ihres neuen Geräts Bedienungsanleitung genau durchlesen. Read the operator's manual carefully. Montage und Einstellung der Schneidausrüstung Check that the cutting equipment is correctly assembled kontrollieren. and adjusted.
Página 4
All manuals and user guides at all-guides.com 1. What is what? Since this manual covers several models, there may be some difference between pictures and your unit. Use the instructions that apply to your unit. 1. Recoil starter 2. Fuel tank 3.
Página 5
All manuals and user guides at all-guides.com 2. Warnings and safety instructions. Operator safety Cutting safety Always wear a safety face shield or goggles. Do not cut any material other than plant Always wear heavy, long pants, boots and hedge. gloves.
All manuals and user guides at all-guides.com 1, 2 Fig.1-1 Fig.1-2 Fig.1-3 3. Assembly procedures 3. Montage 3. Procedimento di montaggio Handle B (3) and Blunt guard (6) for Poignee B (3) et deflecteur (4) a (Fig. 1-1) Manico B (3) e piatto di raccolta (4) (Fig. 1-1) USA/CANADA (Fig.
Página 7
Utilizzare sempre benzina senza piombo tipo gasoline. un taux d'octane de 89. Use Tanaka two-cycle oil or a quality two-cycle Utiliser de l'huile deux temps Tanaka ou une Utilizzare olio per motori a due tempi Tanaka oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil autre huile de qualité...
All manuals and user guides at all-guides.com Fig. 2-2 Fig. 2-2B Fig. 2-2C Starting (Fig. 2-2, 2B) Démarrage (Fig. 2-2, 2B) Avviamento (Fig. 2-2, 2B) CAUTION! IMPORTANT! IMPORTANTE! Before starting, make sure the cutting attach- Avant le démarrage, vérifier que la lame ne Prima di mettere in moto, assicurarsi che ment does not touch anything.
Página 9
All manuals and user guides at all-guides.com Fig. 2-3 Fig. 2-4 Fig. 2-4B Anlassen (Fig. 2-2, 2B) Arranque (FIG. 2-2, 2B) Start (FIG. 2-2, 2B) ACHTUNG! IMPORTANTE! VIKTIGT! Vor dem Anlassen sicherstellen, daß die Antes del arranque, asegúrense de que el Kontrollera före start att skärbladen inte kan Schneidvorrichtung nicht mit irgendwelchen aditamento de corte no esté...
Página 10
HINWEIS! Cutting When cutting, operate engine at full throttle as positions différentes en poussant sur le bouton (THT-210B/2120/2520B, HTD-2526PF/2530PF) de verrouillage (3) et en manœuvrant la (Fig. 2-5) this maintains proper cutter speed. When trimming top of hedge, hold trimmer so poignée.
Página 11
MOTORI NON VEICOLARI. If the cutting attachment still rotates after idle ANMÄRKNING! speed adjustment, contact your service dealer. (THT-210B/2120/2520B, HTD-2526PF/2530PF) Regolazione del carburatore (Fig. 3-1) (Fig. 2-5) Det bakre handtaget (1) kan justeras i sidled för ATTENZIONE! att få...
Página 12
All manuals and user guides at all-guides.com Fig. 3-2 Air filter (Fig. 3-2) Filtro dell'aria (Fig. 3-2) Filtro de aire (Fig. 3-2) The air filter must be cleaned from dust and dirt II filtro dell'aria deve essere sempre pulito per Este filtro debe limpiarse con regularidad in order to avoid: evitare:...
Página 13
All manuals and user guides at all-guides.com Fig. 3-3 Spark plug (Fig. 3-3) Candela (Fig. 3-3) Bujía (Fig. 3-3) The spark plug condition is influenced by: Lo stato della candela é influenzato da: El estado de la bujía es influenciado por: An incorrect carburetor setting.
Página 14
All manuals and user guides at all-guides.com Fig. 3-4 Fig. 3-4B Cutter blade (Fig. 3-4, 4B) Lame (Fig. 3-4, 4B) Hoja de la cortadora (FIG. 3-4, 4B) The blades are installed to the cutter guide with Le lame sono montate sulla relativa guida con 4 Las cuchillas van instaladas en la guía de la the four or five bolts.
Página 15
All manuals and user guides at all-guides.com Fig. 3-5 Fig. 3-6 Gear case (Fig. 3-5) Riduttore (Fig. 3-5) Caja de engranajes (Fig. 3-5) Apply a good quality lithium based grease Applicare del grasso lubrificante al litio di buona Apliquese grasa a base de litio de buena through the grease fitting until a small amount qualitá...
Página 16
All manuals and user guides at all-guides.com Fig. 3-7 Cleaning the cylinder fins (Fig. 3-7) Nettoyage des ailettes du cylindre (Fig. 3-7) Pulizia delle alette del cilindro (Fig. 3-7) When wood chips are caught between cylinder Si des restes de taille, sont coincés entre les Quando frammenti di legno si infilano fra le fins (1), the engine may overheat.
Página 17
All manuals and user guides at all-guides.com Fig. 3-8 Reinigen der Zylinderrippen (Fig. 3-7) Limpieza de las aletas del cilindro (Fig. 3-7) Rengöring av cylinderflänsarna (Fig. 3-7) Wenn sich Holzspäne u. dgl. zwischen den El motor puede recalentarse y perder la Löv och klippspill som fastnar i cylinder- Rippen des Zylinders (1) festsetzen, leidet die potencia cuando queden atrapadas las astillas...
Página 18
Pour toute generale. Per ulteriori informazioni contattare contact your service dealer. information complémentaire, contactez votre l'officina di assistenza. agent Tanaka. Daily maintenance Manutenzione giornaliera Clean the exterior of the hedge trimmer. Entretien quotidien Pulire la macchina esternamente.
Página 19
All manuals and user guides at all-guides.com 6. Specifications / Spécifications / Specificazione / Technische Daten / Especificaciones / Tekniska data MODEL THT-210B/ S/ 1800/ 2120 THT-2520B/ S THT-240B THT-2510/ S THT-2100/ S/ 2000/ L THT-2530/ 2540 Engine Size (ml) ....... 22 (1.34 cu. in.) 24 (1.46 cu.
Página 20
All manuals and user guides at all-guides.com 6. Specifications / Spécifications / Specificazione / Technische Daten / Especificaciones / Tekniska data MODEL HTD-2520PF/ 2522PF HTS-2530PF HTD-2526PF/ 2530PF HTS-2540PF Engine Size (ml) ........... 24 (1.46 cu. in.) Spark Plug ............ NGK BPM-6A or BPMR-6A Champion CJ-8Y or RCJ-8Y Fuel Tank Capacity ( l )........
Página 21
Declaration of conformity Déclaration de conformité Dichiarazione di conformità Konformitätserklärung Declaración de conformidad Konformitetsdeklaration Tanaka Kogyo Co., Ltd., 3-4-29 Tsudanuma, Narashino, Chiba, Japan Nous,soussignés, THT-210B/ S/ 240B/ 1800/ 2000/ L Noi, THT-2100/ S/ 2120/ 2510/ S/ 2520B/ S Der unterzeichnete,...