Denon AVR-2105 Instrucciones De Operación página 15

Setting the delay time
• Input the distance between the listening position and the different speakers to set the delay time for the surround
mode.
Preparations:
Measure the distances between the listening position and the speakers
(L1 to L5) on the diagram at the right).
L1: Distance between center speaker and listening position
L2: Distance between front speakers and listening position
L3: Distance between surround speakers and listening position
L4: Distance between surround back speaker and listening position
L5: Distance between subwoofer and listening position
CAUTION:
Please note that the difference for every speaker should be 6.0 m or less.
NOTE:
• No setting when "None" has been selected for the Speaker Configuration setting.
1
Select the speaker to be set.
8 FRONT L
(Remote control unit)
2
Set the distance between the speaker and listening position.
The distance changes in units of 0.1 meters each time the button is pressed.
Select the value closest to the measured distance.
(Remote control unit)
3
Press the ENTER or
SUBWOOFER MODE setting.
(Remote control unit)
FL Center FR
Subwoofer
L
L
1
2
Listening position
L
5
L
SL L SR
3
4
SBL SBR
3.6m
(down) button to enter the setting and switch the
Setting the Subwoofer mode and Crossover Frequency
This screen is not displayed when not using a subwoofer.
• Set the crossover frequency and subwoofer mode according to the speaker system being used.
1
Select the "Subwoofer Select the setting.
Mode".
(Remote control unit) (Remote control unit)
2
Select the "Crossover Select the frequency.
Frequency" mode.
(Remote control unit) (Remote control unit)
• 40 / 60 / 80 / 100 / 120 /
150 / 200 / 250 Hz can be
selected.
3
Press the ENTER or
Test Tone setting.
(Remote control unit)
ENGLISH
16SW MODE NORM
17CR.OVER 80Hz
(down) button to enter the setting and switch to the
15