Denon AVR-2105 Instrucciones De Operación página 17

5
After completing the adjustment, press the ENTER button.
(Remote control unit)
6
Press the ENTER or
DIGITAL input setting.
(Remote control unit)
NOTES:
• When you adjust the channel levels while in the TEST TONE mode, the channel level adjustments made
will affect all surround modes. Consider this mode a Master Channel Level adjustment mode.
• You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, STANDARD
(DOLBY/DTS SURROUND), 5/7 CH STEREO, MONO MOVIE, ROCK ARENA, JAZZ CLUB, VIDEO GAME,
MATRIX and VIRTUAL.
Setting the Digital In Assignment
• This setting assigns the digital input jacks of the AVR-2105 for the different input sources.
1
Select the digital input jack to be assigned to the
input source.
• To select the digital input jack
(Remote control unit)
19 COAX
2
• To select the input source
Select "OFF" if nothing is connected.
(Remote control unit)
3
Press the ENTER or
Component Video input setting.
(Remote control unit)
NOTE:
• PHONO, TUNER and V. AUX cannot be selected.
(down) button to enter the setting and switch the
CD
(down) button to enter the setting and switch the
Setting the Component In Assignment
• This setting assigns the color difference (component) video input jacks of the AVR-2105 for the different input
sources.
1
Select the component (Y, P
input terminal to be assigned to the input source.
• Component video terminal selection
(Remote control unit)
23 VIDEO1
2
• Input source selection
Select "OFF" if nothing is connected.
(Remote control unit)
3
Press the ENTER or
Surround Mode setting.
(Remote control unit)
Setting the Auto Surround Mode
For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory.
At next time it the same signal inputs, the memorized surround mode is automatically selected and the signal
is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
q
Analog and PCM 2-channel signals
w
2-channel signals of Dolby Digital, DTS or other multichannel format
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
1
Select "ON" if you want to use the auto surround
mode, "OFF" if you do not want to use it.
26 AUTOSURR. ON
(Remote control unit)
2
Press the ENTER or
(Remote control unit)
ENGLISH
/C and P /C ) video
B B R R
DVD
(down) button to enter the setting and switch the Auto
Default Auto Surround Mode
STEREO
II
Dolby PL x Cinema
Dolby or DTS Surround
(down) button to switch the Ext. In SW Level setting.
17