Denon AVR-2105 Instrucciones De Operación página 7

Connecting the video component equipped with Color Difference
(Component - Y, P /C , P /C ) Video jacks
R R B B
• When making connections, also refer to the operating instructions of the other components.
• The signals input to the color difference (component) video jacks are not output from the VIDEO output jack
(yellow) or the S-Video output jack. In addition, the video signals input to the VIDEO input (yellow) and S-Video
input jacks are not output to the color difference (component) video jacks.
• Some video sources with component video outputs are labeled Y, C
terms all refer to component video color difference output.
• At SYSTEM SETUP, the component video input terminal can be assigned for the input sources to which you
want to connect AV devices. (For details, see page 17.)
Connecting a DVD player
DVD player
COMPONENT
VIDEO OUT
B DVD IN jacks
Y C C
B R
• Connect the DVD player's color difference (component) video output jacks
(COMPONENT VIDEO OUTPUT) to the COMPONENT VIDEO-1 IN jack using 75
Ω/ohms coaxial video pin-plug cords.
• In the same way, another video source with component video outputs such as
a TV/DBS tuner, etc., can be connected to the VIDEO-2 color difference
(component) video jacks.
Monitor TV
Connecting a monitor TV
MONITOR OUT jack
COMPONENT
VIDEO IN
Y C C • Connect the TV's color difference (component) video input jacks (COMPONENT
B R
VIDEO INPUT) to the COMPONENT MONITOR OUT jack using 75 Ω/ohms
coaxial video pin-plug cords.
• Video Conversion signals
Signal input to the AVR-2105
Video signal output to VIDEO
MONITOR OUT jack (yellow)
Video signal input jack C
C
S-Video signal input jack
(Down-conversion)
Color difference (component)
E
Video signal input jack
, C , or Y, P , P , or Y, R-Y, B-Y. These
B R B R
• The color difference input jacks may be indicated differently on
some TVs, monitors or video components ("C , C and Y", "R-Y,
R B
B-Y and Y", "P , P and Y", etc.). For details, carefully read the
R B
operating instructions included with the TV or other component.
Monitor Output jacks
Video signal output to color
Video signal output to S-Video
difference (component) Video
MONITOR OUT jack
MONITOR OUT jack
C
E
(Up-conversion)
C E
E C
(C : Video signal output, E : Video signal not output)
Connecting the antenna terminals
DIRECTION OF
BROADCASTING
STATION
FM INDOOR
FM
ANTENNA
ANTENNA
(An accessory)
75 Ω/ohms
COAXIAL
CABLE
AM LOOP
ANTENNA
(An Accessory)
AM loop antenna assembly
Connect to the AM
antenna terminals.
1 2
3
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. With the
antenna on top
any stable
surface.
Mount
b. With the antenna
attached to a
wall.
Installation hole Mount on wall, etc.
ENGLISH
AM OUTDOOR
ANTENNA
GROUND
An F-type FM antenna cable plug can be connected directly.
Connection of AM antennas
1. Push the lever. 2. Insert the 3. Return the
conductor. lever.
NOTES:
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not
disconnect the AM loop antenna.
• Make sure AM loop antenna lead terminals do
not touch metal parts of the panel.
7