Milwaukee T-TEC 201 Instrucciones De Uso página 5

Removing the
tool
Direct reception
of screwdriver
bits
Positioning the
auxiliary handle
Setting the
depth gauge
Tool storage 1.
2.
4
ENGLISH
All manuals and user guides at all-guides.com
Open the chuck by turning the sleeve in
the "RELEASE" direction.
Due to the automatic spindle lock the
chuck cannot be turned when the machine
is idle. Therefore the chuck can be opened
with one hand without steadying.
When turning the sleeve the chucking
power retention is released, after 1/4 turn
the clamping jaws open and release the
clamped tool.
In case of strong tension at the chuck
steady the chuck head with a fork wrench
and loosen the sleeve by hand with a
strong jerk.
Screwdriver bits can be inserted directly
into the working spindle. This results in
the following advantages:
Screwdriver bits can be exchanged easier
and quicker.
Better view at the screw fitting.
The weight of the machine is reduced
when not working with the chuck.
The auxiliary handle can be moved as
required. To move the handle loosen the
wing nut, turn the handle to the required
position and re–tighten the wing nut.
For drilling to specific depth, slide the
depth gauge into the hole provided in the
handle and fasten it at the required drilling
depth.
Press in the lower locking tabs
and pull the storage
compartment out as far as it will go . Screwdriver
bits* and chuck keys* can be taken out.
Press in the upper locking tabs  and
take the storage compartment out
completely . Drill bits* can be taken out.
*Not included in standard equipment,
available as an accessory.
2
3
4
1
T-TEC 201