Milwaukee T-TEC 201 Instrucciones De Uso página 7

Mains
connection
Quik–Lok power
supply cable
Switching the
machine on and
off
Supporting loop
Advice for
operation
Tips on drilling in
masonry
6
ENGLISH
All manuals and user guides at all-guides.com
Connect only to a single-phase AC current supply and only to the mains voltage
specified on the rating plate. Connection to sockets without earth protection is
possible as the appliance features protective insulation to DIN 57 740/ VDE 0740
and CEE 20. Radio suppression complies with the European standard EN 55014.
When fitting the plug, make sure that the brown (live) wire of this appliance is
connected to the plug terminal marked L or coloured red, and the blue (neutral)
wire of this appliance is connected to the
plug terminal marked N or coloured black.
Under no circumstances must the wires of
this appliance be connected to the earth
terminal of the plug marked either E, with
the earth symbol or coloured green or
green/yellow.
Insert the Quik–Lok power supply cable
such that the lug of the plug grasps the
relief of the socket. After inserting lock by
turning clockwise.
Intermittent use
Switching on: Press On-/off switch
Switching off: Release On-/off switch
Continuous use
Switching on: Press the On-/off switch and
then the locking button, after that release
on-off switch.
Switching off: Press the On-/off switch and
then release.
The speed can be infinitely varied by
slowly releasing/pressing the switch
trigger.
When the bow-type handle is mounted, the
machine can be switched on with either
buttons: on the housing or on the bow-type
handle.
A commercial supporting loop can be fixed
in the attachment eye below the handle.
Take the drill out of the hole from time to time to remove dust.
Switch to percussion-drilling for concrete, hard bricks and tiles, stone, hard cement,
and marble (but not when drilling the surface of marble).
For tiles, paving-stones, soft bricks and tiles, soft cement, breeze-block and plaster,
switch to normal drilling.
T-TEC 201