PROBLEM SOLVING
Problem
been switched on
receive signals
Noise is always present in reception mode
It is not possible to communicate with
other parties
Reception is fragmented and/or disturbed
enable transmission
loud voice
Logic related faults (unreadable displayed
12
Possible Cause
installed correctly.
correctly.
An incorrect radio channel has been selected.
the party you are communicating with
obstacles in the transmission path
causes interference (televisions, computers, etc.)
or the transmission has been barred due to a busy
channel.
noise is too high.
Incorrect setting caused by a problem with the power
supply.
Solution
been correctly installed.
Inspect the connections of the battery-charger and the
installation of the batteries.
Move to an another area.
Adjust the volume level.
to the one set by the parties you are communicating
with.
Disable the Monitor function.
are communicating with.
Move to another area.
to the one set by the parties you are communicating
with.
Monitor feature.
Move closer to the party you are communicating with or
to another area.
Increase the distance between the radio and this
If the environmental noise is not high, increase the
sensitivity or use an optional microphone.
power.