Network Standby - Panasonic SC-HC58 Instrucciones De Funcionamiento

Wi-Fi signal strength
To check the Wi-Fi signal strength where the unit is
located.
Preparation
Connect this unit to the wireless network. (l 7)
1
Press [SETUP] repeatedly to select "SIG.LEVEL"
and then press [OK].
≥ The unit's display shows "LEVEL ".
(" " stands for a number.)
2
Press [OK] to exit this display mode.
≥ It is recommended to have a signal strength of "3". Change
the position or angle of your wireless network router or the
unit if the indication is "2" or "1" and see if the connection
improves.
≥ If "LEVEL 0" is displayed, this unit cannot establish a link with
the wireless network router. (l 21)
≥ This function does not work when "D.CONNECT" is set to
"ON".

Network standby

This unit can turn on automatically from standby mode
when this unit is selected as the AirPlay speakers.
Preparation
Connect this unit to the wireless network. (l 7)
1
Press [SETUP] repeatedly to select "NET STNBY"
and then press [OK].
2
Press [3, 4] to select "ON" and then press [OK].
≥ To cancel this function, select "OFF" in step 2.
≥ The factory preset is "OFF". If this function is set to "ON" the
standby power consumption will increase.
18
RQT9759
All manuals and user guides at all-guides.com
Display the name for the connected wireless network
(SSID).
1
2
≥ If "NOCONNECT" is displayed this unit is not connected to a
≥ All letters are displayed as capital letters, and characters that
To check the unit's IP address or the Wi-Fi MAC
address.
1
2
≥ To exit the setting, wait 20 sec.
≥ The " – " displayed on the top or bottom left of the display
Wireless network name (SSID)
Press and hold [– NETWORK SETUP] on the unit
and [OK] on the remote control until the unit's
display shows the SSID.
Press [OK] to exit.
wireless network.
cannot be displayed are replaced with "¢".
IP/MAC Address
Press and hold [– NETWORK SETUP] on the unit
and [4] on the remote control until the unit's
display shows the IP address.
{. The IP address is partially displayed.
≥ To display the MAC address on the unit, repeat the
steps above by replacing [4] with [3].
Press [3, 4] on the remote control to show the
rest of the IP address.
indicate the first and last units respectively.