Others; Automatic Standby; Display Brightness; Checking The Software Version - Panasonic SC-HC58 Instrucciones De Funcionamiento

Others

Automatic standby

As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for approx. 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [3, 4] to select "OFF" and then press [OK].
≥ To turn automatic standby on, select "ON" in step 2.
≥ This setting cannot be selected when "FM" is the source.

Display brightness

The brightness of this unit's display can be changed.
1
Press [SETUP] repeatedly to select "DIMMER".
2
Press [3, 4] to select "ON" and then press [OK].
≥ To cancel the dimmer, select "OFF" in step 2.
Changing the unit and remote
control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [CD] to select "CD".
2
While pressing and holding [SELECTOR] on the
unit, press and hold [CD/RADIO] on the remote
control until the unit's display shows "REMOTE 2".
3
Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.
≥ To change the mode back to "REMOTE 1", repeat the steps
above but replace the button pressed on the remote control
from [CD/RADIO] to [ ].
All manuals and user guides at all-guides.com
Occasionally, Panasonic may release updated
software for this unit that may add or improve the way
a feature operates. These updates are available free of
charge.
Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (l 7)
– Make sure that the wireless network is connected
– If "D.CONNECT" is set to "ON", change the setting
1
2
DO NOT DISCONNECT the AC mains lead while
one of the following messages is displayed.
– "LINKING", "UPDATING" or "
("
≥ During the update process, no other operations can be
performed.
3
4
≥ Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
≥ If you do not want to update the unit, select "UPDATE? N"
and then press [OK] in step 2.
≥ If there are no updates, "NO NEED" is displayed after step 2.

∫ Checking the software version

1
2
Software update
to the Internet.
to "OFF" and connect this unit to a wireless
network that is connected to the Internet.
Press [SETUP] repeatedly to select
"SW UPDATE" and then press [OK].
Press [3, 4] to select "UPDATE? Y" and then
press [OK] to start the update.
" stands for a number.)
When the update has finished successfully,
"SUCCESS" is displayed.
Disconnect the AC mains lead and reconnect it
after 3 minutes.
Press [SETUP] repeatedly to select "SW VER." and then
press [OK].
{. The version of the installed software is displayed.
Press [OK] to exit.
%"
17
RQT9759