Panasonic SC-HC58 Instrucciones De Funcionamiento página 21

Ocultar thumbs Ver también para SC-HC58:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Messages
The following messages or service numbers may
appear on the unit's display.
"--:--"
≥ You plugged the AC mains lead in for the first time or there was a
power failure recently. Set the time (l 16).
"ADJUST CLOCK"
≥ Clock is not set. Adjust the clock accordingly.
"ADJUST TIMER"
≥ Play timer is not set. Adjust the play timer accordingly.
"AUTO OFF"
≥ The unit has been left unused for about 30 minutes and will shut
down within a minute. Press any button to cancel it.
"CANNOT SET"
≥ Select an audio source other than "AIRPLAY" or "BLUETOOTH".
"CHECKING CONNECTION"
≥ The unit is checking the connected iPod/iPhone/iPad.
≥ If this display keeps appearing, make sure that the battery of the
iPod/iPhone/iPad is not depleted and that the iPod/iPhone/iPad is
turned on and connected correctly (l 6).
"DL ERROR"
≥ The software download has failed. Press any button to exit.
Please try again later.
≥ The server cannot be found. Press any button to exit. Make sure
that the wireless network is connected to the Internet.
"ERROR"
≥ Incorrect operation is performed. Read the instructions and try
again.
"F
" ("
" stands for a number.)
≥ There is a problem with this unit.
Note down the displayed number, disconnect the AC mains lead
and consult your dealer.
"FAIL"
≥ Updating or setting has failed. Read the instructions and try again.
"ILLEGAL OPEN"
≥ Sliding door is not in correct position. Turn the unit off and on
again. If this display appears again, consult the dealer.
"IPOD_DOCK OVER CURRENT ERROR"
"IPOD_PORT OVER CURRENT ERROR"
≥ The iPod/iPhone/iPad is drawing too much power. Disconnect the
iPod/iPhone/iPad and turn the unit off and on again.
≥ The USB device is drawing too much power. Switch to "CD"
mode, remove the USB and turn the unit off.
"LEVEL 0"
≥ There is no link between this unit and the wireless network router.
Try the following operations:
– Check that the wireless network router is turned on.
– Turn this unit off and on again.
– Reset the wireless network settings. (l 7)
If the problem persists, consult your dealer.
All manuals and user guides at all-guides.com
"LEVEL j"
≥ When "D.CONNECT" is set to "ON" the Wi-Fi signal strength
cannot be checked. To check the Wi-Fi signal strength from the
wireless network router, set "D.CONNECT" to "OFF". (l 11)
"LINKING"
≥ This unit is communicating with the wireless network router to
complete the network settings.
Depending on the wireless network router this process may take a
few minutes. Try moving this unit closer to the wireless network
router.
"NOCONNECT"
≥ This unit is not connected to the network.
Check the network connection. (l 7)
"NODEVICE"
≥ The iPod/iPhone/iPad device is not inserted correctly. Read the
instructions and try again (l 6).
≥ The battery of the iPod/iPhone/iPad is depleted. Charge the iPod/
iPhone/iPad and turn it on before connecting.
≥ The USB device is not inserted. Check the connection.
"NO DISC"
≥ Insert the disc to be played (l 6).
"NO PLAY"
≥ A CD that is not in CD-DA or MP3 format is inserted. It cannot be
played.
≥ If there are more than 255 albums or folders (audio and
non-audio), some of the MP3 files in these albums may not be
read and played. Transfer these music albums to another USB.
Alternatively, reformat the USB device and save these music
albums prior to saving the other non-audio folders.
"NOT SUPPORTED"
≥ You have connected an iPod/iPhone/iPad that cannot be played
(l 22).
≥ If the iPod/iPhone/iPad is compatible, turn it on and connect it
correctly.
≥ The connected iPod touch/iPhone/iPad is not connected to a
wireless network. Connect it to a wireless network and try again.
(l 7)
"READING"
≥ The unit is checking the CD information. After this display has
disappeared, start operating.
"REMOTE " ("
≥ The remote control and this unit are using different codes. Change
the code on the remote control.
– When "REMOTE 1" is displayed, press and hold [OK] and [
– When "REMOTE 2" is displayed, press and hold [OK] and [CD/
"SET WI-FI"
≥ The connected iPod touch/iPhone/iPad is not connected to a
wireless network. Connect it to a wireless network and try again.
(l 7)
" stands for a number.)
for more than 4 seconds.
RADIO] for more than 4 seconds.
]
21
RQT9759

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido