Num'axes PIE1060 Manual De Instrucciones página 21

PIR interval
PIR sensor sensitivity
Time Lapse
Cycle recording
IR LED brightness
Low power night
capture
PIE1060 - Indice B – Mars 2022
Default PIR interval: 20 seconds
Programmable from 5 seconds (00:05) to 59 minutes 59 seconds (59:59)
Press "OK" to set the time interval that you desire between photos/videos
upon motion detection by the PIR sensor. This option avoids camera taking to
many photos or videos.
Example: if the PIR interval is set to 01:00, the camera will wait 1 minute
between photo/video recordings with motion detection.
High | Medium | Low
High sensitivity:
1) is more sensitive to movements by smaller subjects;
2) offers longer detection distance;
3) makes it easier for the PIR sensor to detect a difference between body heat
and outdoor temperature;
4) makes it easier to trigger the camera.
In high temperature environment, subjects body heat and environment
temperature are hard to tell by the camera, the suggested setting is high.
It is recommended to use low PIR sensitivity in environments with lots of
interference like hot wind, smoke, near window, etc.
OFF | ON
With Time Lapse ON, the camera will capture photos and/or videos
automatically at a pre-set time interval.
WARNING: when the Time Lapse parameter is set to ON, the PIR sensor is
deactivated (there is no motion detection).
Select "ON" then press the OK button to set the time interval. The camera will
shoot photos and/or videos automatically upon this set interval.
The Time Lapse parameter is programmable from 5 seconds (00:00:05) to
23 hours 59 minutes and 59 seconds (23:59:59).
Example: if Time Lapse is set to 00:30:00, the camera will automatically
capture photos/videos every 30 minutes.
The "Time Lapse" feature can work together with the "Operating periods"
feature.
OFF | ON
When the memory card will be full, the camera will continue to record
photos/videos by deleting the oldest photos/videos.
Select "OFF" then press the OK button to deactivate the cycle recording
function.
Auto | Medium | Low | OFF
This parameter allows you to adjust the brightness of the infrared flash
No IR flash | No capture
− No IR flash: At night, if the power level is too low (solar panel battery, AA
batteries), the device will take photos/videos without triggering the
infrared flash.
− No capture: at night, if the power level is too low (solar panel battery, AA
batteries), the device will no longer take photos/videos.
21/88