Turn On The Camera - Num'axes PIE1060 Manual De Instrucciones

Camera password
Bluetooth
Wi-Fi name (SSID)
Wi-Fi password
Wi-Fi auto power off
Camera auto power off
LCD screen standby
Version
Firmware update
7. Operation
7.1.

Turn ON the camera

Any time after the batteries and memory card have been inserted, you can switch on the camera.
Put the switch in the "ON" position; the camera is ready to work.
The red indicator light located on the front of the camera will blink and the LCD display will count down
5 seconds. This interval allows you time to close the camera front cover and leave the monitored area.
Once in the ON mode, the camera will take photos or videos according to its current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings. In order to test or use the device,
you only need to insert the SD card and AA batteries then power on the camera (switch in the ON position).
PIE1060 - Indice B – Mars 2022
OFF | ON
Select "ON" then press "OK" to enable password protection for your camera
(4 digits/letters).
OFF | ON
Default name: NUMAXES PIE1060-
Default password: 12345678
1 minute | 2 minutes | 3 minutes
If the camera activates the Wi-Fi hotspot, but the smartphone does not
connect to it successfully within the selected time, the Wi-Fi hotspot will
automatically be deactivated and the camera will return to SETUP mode or
ON mode.
When the smartphone is more than 15m / 49ft. away from the camera, the
Wi-Fi hotspot is automatically deactivated.
OFF | 3 minutes | 5 minutes | 10 minutes
In SETUP mode, the camera will automatically power off after 3, 5 or 10
minutes without any press on the keypad. Slide the switch to the OFF position
then back to the SETUP position if you want to continue the settings.
If you select OFF, there is no automatic shutdown of the camera in SETUP
mode.
OFF | 1 minute | 3 minutes | 5 minutes
In SETUP mode, the LCD screen will automatically go to sleep after 1, 3 or 5
minutes of no activity. Press any key to wake up the screen.
If you select OFF, the screen does not go to sleep in SETUP mode.
This parameter shows the following information: MCU | MCUVER | DSPVER
Insert the memory card with the update firmware inside.
Red LED: power on indicator light
24/88