Technical Data - Hilti VC 75-1-22 Manual Del Usuario

Status
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
4

Technical data

Weight
Rated voltage (DC)
Rated current input
Maximum volumetric flow rate (air)
Max. volume flow rate (end of hose)
Max. vacuum
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on the product.
The appliance may be operated only by authorized, trained personnel.
5.1 Installing clip 2
Install the clip prior to initial start-up.
▶ Push the clip into its mounts until the clip snaps into engagement.
Make sure that the holder for the shoulder strap is facing up.
5.2 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 5
*2284804*
Meaning
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
2284804
VC 75-1-22
4.6 kg
(10.1 lb)
21.6 V
16 A
35 ℓ/s
(9 liq. gal /s)
US
82 m³/h (23 ℓ/s)
(2,900 ft³/h
(6 liq. gal /s))
US
11 kPa (110 mbar)
(2 psi (1.6 psi))
21.6 V
See the end of these
operating instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
English 7