Periodic Maintenance; Clean The Rear Panel - Fri-Jado Bake Basic 3 - E Instrucciones De Manejo

5.2.

Periodic maintenance

Part Action
•
Exterior
•
•
•
Windows
•
•
Door switch
•
•
•
Foil of the operating
•
panel
•
Mains lead
•
•
Rubber door seal
•
•
Rear panel
•
•
Hinges
5.3.

Clean the rear panel

WARNING
• Avoid bumping against the fan blades to prevent imbalance.
• Allow the oven to cool to avoid burning.
•
Remove the plug from the wall socket before removing the rear panel.
1. Remove the racks or baking trays and the beams
supporting the racks or baking trays.
2. Remove the four nuts using the spanner delivered
with the oven and keep them carefully.
3. Pull the rear panel forward and remove it from the
oven.
4. Clean the rear panel with hot water and Fri-Jado
Cleaner. In case of heavy contamination, spray with
Fri-Jado Cleaner, let it soak and rinse thoroughly.
5. Remove dirt from the bottom of the oven and from
the now visible inner rear panel with a soft brush.
6. Place back the rear panel and tighten the four nuts
with the delivered spanner.
Clean the exterior with a small amount of water to which a mild
cleaning agent has been added and a soft brush or sponge.
Dry the exterior with a cloth.
Use stainless steel cleaning spray for removing stains and to make
the outside shine again.
Open the door.
Clean the windows with warm soapy water or Fri-Jado Cleaner.
Check if the door switch can move freely (P-model only).
Have a door switch that cannot move freely replaced.
Clean the visible part of the door switch with a dry cloth.
Check the foil of the operating panel for damage.
Replace a torn foil.
Inspect the electrical cord for damage.
Have a defective mains lead replaced by an authorised installer.
Check the rubber door seal for cracks.
Replace the rubber if cracked.
Clean the rear panel and the space behind it.
See chapter 5.3).
Spray moving parts with silicone oil.
en / 2-17
Bake Basic 3/5 - E & P
Cleaning
frequency
Weekly
Weekly
Weekly
Weekly
Monthly
Monthly
Monthly
Every 6 months
9123573_1007