Problems - Fri-Jado Bake Basic 3 - E Instrucciones De Manejo

Bake Basic 3/5 - E & P
6.

Problems

WARNING
• If the problem is not solved by consulting the table below, proceed as follows:
1. Switch off the unit.
2. Remove the plug from the outlet.
3. Close the water supply.
4.
Contact your supplier/service agency. Make sure you have the following data at hand:
model and serial number.
•
If the lead is damaged, immediately contact your supplier/service agency.
•
All windows used in the unit are made of tempered glass with a reflecting layer. Use the
same material when windows need replacement.
•
The required electric diagrams are to be fount in the electric area.
Part
Element
Fan
Oven
Steam
(with Bake Basic - P only)
Door
Bottom
(with Bake Basic-P only)
9123573_1007
Problem
The heating element colours
red
The fan does not rotate
The oven does not become
hot
No steam injection
Does not close
The bottom becomes wet
en / 2-18
Action
• Remove the plug from the outlet.
• Have the fault corrected.
•
Remove the plug from the outlet.
• Open the door.
• Remove the rear panel (see chapter 5.3)
and check if the fan can rotate freely.
• Open and close the door.
• Check the fuses and the earth leakage
switch in the meter cupboard.
• Check the water connection.
• Place the oven in a horizontal position
such that the closing pins fall into the
door hinges.
• Check if the door switch is not
positioned too far to the outside.
• Reduce the number of steam pulses.