Adjusting The Color - Sony GDM-90W01T Manual De Instrucciones

Adjustments (Expert mode)
CANCEL MOIRE:
Cancels the moire when "ON" is selected.
The adjustment data becomes the individual setting for
each input signal received.
MOIRE ADJ:
Reduces fuzziress of the picture caused by canceling
moire.
Adjust beginning from 0 until the moire is minimum.
The adjustment data becomes the individual setting for
each input signal received.
LANDING:
See "Landing" on page 10.
The adjustment data becomes the common setting for all
input signals received.
DEGAUSS:
See "Degaussing the screen" on page 15.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the
To reset, press the ? (reset) button while the OSD is on.
The selected parameter is reset.

Adjusting the color

The adjustment data becomes the common setting for all
input signals received.
1
Press the button.
The "COLOR" OSD appears.
COLOR
COLOR TEMPERATURE
5 0 0 0K 65 0 0K
VAR I ABLE
R B I AS
G B I AS
B B I AS
R GA I N
G GA I N
B GA I N
SELECT
2
Press the >?// button to select the color
temperature to adjust, 5000, 6500 or 9300.
3
Press the ¨./> button to select and the >?//
button to adjust the parameter.
VARIABLE:
Adjusts the color selected in step 2 to the desired color
temperature. The figure of the selected color
temperature changes.
R BIAS/G BIAS/B BIAS:
Adjusts the black level of each signal. "++" appears at
the right shoulder of the adjusted color temperature.
R GAIN/G GAIN/B GAIN:
Adjusts the white level of each signal. "++" appears at
the right shoulder of the adjusted color temperature.
The OSD automatically disappears after about 30 seconds.
To turn off the OSD, press the
14
button again.
EXPERT
9 3 0 0K
1 0 0
50
50
50
50
50
50
SET / ADJUST
button again.
To reset all parameters of a particular color
temperature
Select the color temperature in step 2, and then press the ?
(reset) button. All parameters of the color temperature are
reset and "++" at the right shoulder disappears.
To reset a particular parameter of a particular color
temperature
Select the parameter in step 3, and then press the ? (reset)
button. Only the selected parameter of the color
temperature is reset.
Resetting to the factory-
preset levels
Reset in the same way as described in "Resetting to the
factory-preset levels" on page 11.