Sony VPL-ES1 Manual De Instrucciones página 40

4
Insert the new lamp all the way in until
it is securely in place. Tighten the
screws. Fold the handle.
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
5
Close the lamp cover and tighten the
screws.
6
Turn the projector back over.
7
Connect the power cord. The ON/
STANDBY indicator around the
key lights in red.
40
GB
Maintenance
8
Press the following keys on the remote
commander in the following order for
less than five seconds each: RESET,
b , B , ENTER.
Notes
• Be sure to use the LMP-E180 Projector
Lamp for replacement. If you use lamps
other than LMP-E180, the projector may
cause a malfunction.
• Be sure to turn off the projector and unplug
the power cord before replacing the lamp.
• Do not put your hands into the lamp
replacement spot, or not fall any liquid or
object into it to avoid electrical shock or
fire
Disposal the used lamp
The used lamp contains Mercury, dispose
according to local, state or federal laws.
As the materials used in this lamp are similar
to those of a fluorescent lamp, you should
dispose of a used projector lamp in the same
way as a fluorescent lamp.
=/1