Use Of The X-Ray Device; Patient Positioning; Positioning The X-Ray Head; Hypersphere Technology - Myray RX DC Instrucciones De Uso

4. USE OF THE X-RAY DEVICE

4.1. PATIENT POSITIONING

A positioner or alignment device specific for the selected image receiver should always be used to assure the x-rays
are correctly aligned regardless of the position the patient's head is in.

4.2. POSITIONING THE X-RAY HEAD

Position the x-ray head so that the cone is aligned with the image receiver.

4.2.1. HYPERSPHERE TECHNOLOGY

NOTE: Firmly hold the head with both hands when putting it in place.
It is possible to set a safety unlocking mode that allows the head to be turned only by pressing both unlock buttons.
This prevents the head from unlocking unexpectedly after one of the two unlock buttons has been accidentally
pressed. To activate this mode, refer to "Advanced options" in chapter 5.
EN
RX DC Plus versions feature Hypersphere technology that allows the x-ray head
to turn endlessly on both the horizontal and vertical planes.
The x-ray head is initially blocked by an electromechanical brake. The head can
be tilted into the position required to take the x-ray by touching the unlock areas
(see points A.as shown in the figure).
The head can be tilted into the position required to take the x-ray by touching the
unlock areas. To lock it again, release the unlock areas.
OPERATOR'S MANUAL
67