Black and Decker NHT518 Manual De Instrucciones página 7

Ocultar thumbs Ver también para NHT518:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

90554620 NHT518, NHT524.qxd: chainsaw booklet new
WARNING
:
Fire hazard. Do not store or carry
battery so that metal objects can contact exposed battery
terminals. For example, do not place battery in aprons, pockets, tool
boxes, product kit boxes, drawers, etc., with loose nails, screws,
keys, etc. Transporting batteries can possibly cause fires if the
battery terminals inadvertently come in contact with conductive
materials such as keys, coins, hand tools and the like. The US
Department of Transportation Hazardous Material Regulations (HMR)
actually prohibit transporting batteries in commerce or on airplanes
(i.e., packed in suitcases and carry-on luggage) UNLESS they are
properly protected from short circuits. So when transporting individual
batteries, make sure that the battery terminals are protected and well
insulated from materials that could contact them and cause a short
circuit.
STORAGE RECOMMENDATION
1. Store trimmer:
a.) with the battery removed and on the charger
b.) in a place that is cool and dry away from direct sunlight and
excess heat or cold.
c.) out of the reach of children
2. For prolonged storage such as over the winter, the battery should
be fully charged and then removed from the charger. It should be
charged again just prior to using it in the Spring. Store as
referenced in a, b and c above.
CHARGING
PROCEDURE
1. Plug the charger into any
standard 120 Volt 60 Hz
electrical outlet.
2. Slide the charger onto the
battery pack as shown in
figure 1 and let the battery
pack charge initially for 11
9/11/09
7:50 AM
1
7
Page 7
hours. After the initial charge, under normal usage, your battery
pack should be fully charged in 9 to 11 hours.
2a) During charging the green LED will appear.
2b) When charging is complete the green LED will go off.
3. Unplug charger, and remove the battery
pack. Place the battery pack into the
tool until it "clicks" into place (fig. 2)
NOTE: To remove the battery pack, press
down on the release button on the back of
the battery pack and slide out.
OPERATION
SWITCH
To turn the unit "ON", slide the lock off
button, shown in figure 3, forward and,
squeeze the trigger switch. Once the unit is
running, you may release the lock off button.
In order to keep the unit running you must
continue to squeeze the trigger. To turn the
unit "OFF", release the trigger.
TRIMMING INSTRUCTIONS
1. WORKING POSITION – Maintain
proper footing and balance and do
not overreach. Wear safety goggles,
non-skid footwear and rubber gloves
when trimming. Hold the unit firmly in
both hands and turn the unit ON.
Always hold the trimmer, as shown
in the illustrations in this manual,
with one hand on the switch handle
and one hand on the bail handle.
(figure 4) Never hold the unit by the
blade guard.
2
3
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nht524

Tabla de contenido