User Manual; Assembly Of Upper Part And Base; Assembly And Replacement Of Springs; Assembly And Replacement Of Springs (Micro) - Vela Meywalk 4 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.0. USER MANUAL

SMALL,
MEDIUM
& LARGE
MICRO
1 2

2.0.1. ASSEMBLY OF UPPER PART AND BASE

The upper part is placed in the risers on the chassis. The upper
part is lowered into place in the two risers.
Note: The handle must face the swivel front wheels.

2.0.2. ASSEMBLY AND REPLACEMENT OF SPRINGS

Release the tilt bar and raise it to the upper position so the
lower risers appear in front of the rear wheels. Push and turn
the black plug at the bottom to remove it, so the springs will
appear. Fit/replace the spring and slide the plug up into the
groove and turn in place until it locks.

2.0.3. ASSEMBLY AND REPLACEMENT OF SPRINGS (MICRO)

Lift the upper part of the gait trainer (see section 2.0.1.). The
springs can now be mounted/replaced.

2.0.4. HEIGHT ADJUSTMENT

Loosen the handles on both sides and adjust the frame to the
desired height. It is important that the height is adjusted equally
on both sides of the frame. Tighten the handles again on both
sides. Note: Never perform height adjustment while the gait
trainer is in use.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

014000013000011200011250

Tabla de contenido