Kinderkraft MYWAY Manual De Uso página 46

• Join two buckle latches to engage them and insert them into the buckle (D) until you hear
a "click" (fig. 4.4d).
4.5 Tightening the harness (Fig. 4.5)
• Pull the shoulder straps to eliminate play in the hip strap so that the harness lies flat.
• Pull the harness with the harness adjustment strap, until the harness lies flat and close to
the child's body. Ensure that the shoulder straps fit well to the child's shoulders. Proper
tension is ensured, if you can insert one finger (approx. 1 cm) between the shoulder strap
and the chest of the child.
NOTE The harnesses lap straps must be placed as low as possible on the child's hips. Make
sure that the harness straps are not twisted.
5. Installation in the vehicle
In case of sudden braking or an accident, persons not using seat belts can cause damage to
other passengers.
Always check the following:
• The seat backrests are locked in the vehicle (i.e., foldable back seat is locked).
• All heavy objects and sharp edges are secured (e.g., on the rear parcel shelf).
• All passengers fastened their seat belts.
• The safety seat is always protected, even if the child is not in it.
Vehicle security
Seat covers in some vehicles can be made of soft materials so the safety seat may leave some
traces. They can be avoided by placing a blanket or towel under the safety seat.
5.1 Installing the rear-facing child safety seat in weight groups 0+ and 1 (up to 18 kg) using
the vehicle 3-point safety belts.
• Place the child seat on the vehicle's seat close to the backrest. The child seat must be placed
in the rearward-facing position. The tilt of the backrest of the seat must be set in position
"4", which is the most inclined (Fig. 5.1a).
• Pull out the safety belt as much as possible. Pull the lap strap pas through the guide slots
(G) under the armrests and secure the seat belt buckles (Fig. 5.1b).
• Pull the shoulder belt over the child seat through the blue belt guide on the back of the
child seat (J) (Fig. 5.1).
Note: Tighten the belt up and make sure that the car safety belt has not twisted or slipped
from the guides.
• Push the baby seat to the car seat.
• Pull the lap belt towards the buckle to fasten it. Then, pull the shoulder belt to tighten the
other parts of the safety belt.
NOTE: Make sure the child safety seat is fixed well and stable. Check the belt and make sure
its route goes on correctly.
• Secure the child in the seat in accordance with sec. 4.4 and 4.5 (Fig. 5.1d).
46