Kinderkraft MYWAY Manual De Uso página 47

5.2 Installing the child's seat in weight group 1 (9-18kg) using ISOFIX system and the top
tether strap.
IMPORTANT The instruction manual of the vehicle manufacturer specifies the location of the
ISOFIX attachment points and the top tether strap, and other necessary information regarding
the installation of the seat in the car. The user MUST read the instruction manual of the vehicle
manufacturer.
• Open the cover of the child seat compartment (Fig. 5.2a).
• Take out the strap with the hook (Fig. 5.2b), then place it on the child headrest and close
the compartment.
• Press on both sides of the ISOFIX release button (H) and pull out the ISOFIX attachments
(M) as far as possible (Fig. 5.2c).
• Attach ISOFIX guides to the seat connectors (Fig. 5.2d).
• Grab the seat with both hands and push the two fixing hooks in the back seat.
• When you hear the "click" of each ISOFIX attachments, push the seat to the back seat,
strongly and evenly pressing its both sides (Fig. 5.2e)
NOTE! The locking attachments are secure only when both button markers are completely
green.
• Grab the child seat and make sure it is securely fastened without play. If it moves and ISOFIX
attachments slip out, repeat the previous steps.
• Set the backrest of child seat in position in desired position "1" to "3".
NOTE: Any change in the tilting of the child seat during its use, requires the re-adjustment
of the top tether strap.
• Press the button releasing the buckle to adjust the length of the top tether strap (Fig. 5.2f).
The strap must be long enough to allow placing the hook in the attachment point in the
back seat.
• Place the top tether hook in the attachment point of the vehicle recommended in the
instruction manual of the vehicle manufacturer (Fig. 5.2g).
• Pull the other end of the top tether strap in order to tighten it. The upper strap is properly
tightened, when the green indicator in buckle is visible (fig. 5.2h).
• Secure the child in the seat in accordance with sec. 4.4 and 4.5 (Fig. 5.2i).
5.3 Installing the front-facing child safety seat in weight group 1 (9kg-18kg), using the
vehicle 3-point safety belts.
• Place the child seat on the vehicle's seat close to the backrest. The child seat must be placed
in the front-facing position. Set the backrest of child seat in position in desired position "1"
to "3" (Fig. 5.3a).
• Pull out the car's safety belt as much as possible. Pull the lap strap pas through the guide
slots (G) under the armrests and secure the seat belt buckles (Fig. 5.3b).
Pull the shoulder part of the vehicle's seat belt through the child seat and under the
headrest. Do not guide the strap through the headrest guide (Fig. 5.3c).
Note: Make sure that the car safety belt is not twisted.
• Push the baby seat to the car seat.
47