your body´s natural balance.
• Individuals undergoing medical treatment or therapy in these specific areas should
consult with their physician before using this type of product.
Regarding the seat and cover:
• Soft-close seat and cover.
• The dampers in the seat and cover provide a slow and silent closure. Do not press
any of these two parts with your hand as you might damage the operation of the
damper.
1.1.2 INSTALLATION PRECAUTIONS
This product should only be installed by qualified staff and with the provided components. Please
check the installation manual in order to obtain more information on the electrical and water connec-
tions.
Make sure you fulfil the following precautions regarding the hydraulic installation:
• Always connect the In-Wash to the domestic cold water mains.
• Rain water, demineralized water, sea water or grey water are not suitable to operate this equipment.
The In-Wash + In-Tank shower toilet may only be operated with normal drinking water.
• When installing the water filter, make sure it is tightened adequately and in its correct position.
• The pressure of the water supply of this device should be within the range of 0,05 to 0,9 MPa.
Make sure you fulfil the following precautions regarding the electrical installation:
• Do not handle the socket with wet hands: To remove the plug from the power outlet, do not pull the
cable, always pull the plug.
• Always unplug the power cable before handling the product.
• Always use the specified supply voltage (220-240V, AC 50/60 Hz). The product should have an earth
connection. It is necessary to install a circuit breaker.
• Do not use a poor or defective electrical connection.
• Place the socket correctly. It should be properly connected to the power outlet, firmly and comple-
tely.
• Remove the dust from the power outlet.
• Do not bend or squeeze the connecting tube or the power cable; and keep the cable away from
humid, hot or sharp surfaces.
• Do not install the product in wheeled vehicles or boats.
Ignoring these precautions may cause fire, electric shock, short-circuit or damages to the device.
To confirm that the installation is correct:
• Check that the vitreous china piece is installed according to the provided installation manual.
• Check that the shut-off valve is open.
• Check that the power supply is connected to the In-Wash + In-Tank.
• Check that the remote control is connected to the In-Wash + In-Tank. (Should this not be the case,
please see section 2.2.1).
When the In-Wash is connected to the power supply, the lights blink and a long beep may be heard.
The nozzle moves outwards and inwards.
The lights switch off and the In-Wash remains in a Stand-by mode, ready to be used.
1.1.3 PRECAUTIONS FOR USE
These precautions are important for a safe use. Make sure you follow them and use the product properly.
The In-Wash is a WC that has been designed for the cleaning of the anal and perineal areas. It has
been designed mainly for private use. Its use is restricted to enclosed spaces. Any other use will not
be deemed in accordance with its purpose and Roca will not accept any responsibility for the conse-
quences that might arise from an improper use.
17