Storage; Disposal; Troubleshooting - HOLZMANN MASCHINEN TKS500S Instrucciones De Servicio

17.3 Storage

Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!

17.4 Disposal

Observe the national waste disposal regulations. Never dispose of the ma-
chine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options availa-
ble.
If you buy a new machine or an equivalent device from your specialist retail-
er, he is obliged in certain countries to dispose of your old machine properly.
18

Troubleshooting

Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem!
Trouble
Machine does not start
Burn marks on the workpiece
Low power / motor overload
Saw blade get loose after mo-
tor is switched off
Workpiece clamped while ad-
vancing
Wrong saw blade direction
HOLZMANN MASCHINEN GmbH
NOTE
WARNING
Possible cause
 Emergency stop switch to
switch off
 switch or a phase is broken
 Overload protection is trigge-
red.
 Safety fuse is blown
 Open cover plate for saw
blades
 The blade is blunt
 Wrong saw blade
 Rip-fence not parallel to saw
blade
 Dull saw blade
 Only 2 phases intalled
 Fixing nut too lightly fastened

 dull blade
 Riving knife thickness does not
match the used blade
 Socket wrongly tapped
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
 Turn the emergency OFF switch
to the right to unlock to
 Repair the defective circuit or
the faulty phase
 Wait until the engine cools
down
 Replace the fuse
 Cover plate close
 Replace the blade
 Replace the blade
 Adjust rip-fence
 Replace blade
 Check power supply
 Tighten fixing nut

 Replace with sharp blade
 Splitting wedge thickness must
be greater than or equal to
blade thickness.
 Change polarity of socket
(phase-changing)
35
TKS500S