HOLZMANN MASCHINEN TKS500S Instrucciones De Servicio página 30

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOLZMANN MASCHINEN GmbH
Assembly rip-fence
NOTE do not tighten yet.
Assembly mitre gauge:
Carry out adjustment:
Adjust the 90° angle between the stop (3) and the
saw blade using the hexagon head screw (2). (Use a
right angle gauge...not included in the scope of de-
livery and then make a test cut for verification).
Assembly transport wheels
Assembly hook for push-stick -tools:
Attach the hook to the frame using the nut
www.holzmann-maschinen.at
Fasten the clamping device (1) for the rip-
fence(stop) to the table top with two cheese
head screws M6, two washers and two nuts.
Attach the fixing plate (2) to the stop fixing (3)
using two M6 screws, two washers and two nuts.
Insert stop
High contact surface in position (A)
Low contact surface in position (B)
and then clamp it.
Insert rip fence in clamping device
Operation instruction:
Locking/clamp = lift flap
release = press down the flap
Insert a round-head screw M8 x 70 from below
into the mitre gauge, fix with 8 mm washer and
handle.
Assemble the wheel group (1) to the lower sup-
port leg using bolts and nuts.
ASSEMBLY
30
TKS500S

Publicidad

Tabla de contenido
loading

Tabla de contenido