Mitre Cuts (Cross-Cuts) And Wedge-Cutting; Cleaning, Maintenance, Storge, Disposal; Cleaning - HOLZMANN MASCHINEN TKS500S Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

16.3.2

Mitre cuts (cross-cuts) and wedge-cutting

When performing this operation, the following equipment shall be used for safe working:
 Mitre gauge (ready for use by lifting onto the saw table)
 the guard of the saw blade
 the riving knife
 the insert in the table
Cross-cuts:
Mitre cuts in the range 0-90° can be carried out by pressing the workpiece to be cut firmly
against the stop surface of the mitre gauge.
Wedge cuts:
To do this, set the rotary part to 0° and secure it with the adjusting handle. Place the workpiece
in the recess and saw through with even pressure.
Feed only with the hand on the mitre gauge (hands away from the wood)
Only remove workpieces (wedges) after the machine has come to a stand-
still. To do this, switch off the machine and wait for the saw blade to come
to a standstill.
17

CLEANING, MAINTENANCE, STORGE, DISPOSAL

17.1 Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is also a prerequisite for the safe operation of the machine and its long service
life. Therefore, clean the device after each use and remove dust and dirt. Use personal protective
equipment (gloves and eye protection when using compressed air). Ensure that the saw blade
protection is free from wood residues and sawdust. Cleaning is best done with compressed air or
a hand brush. Also make sure that you keep the table surface free of resin.
HOLZMANN MASCHINEN GmbH
CAUTION
WARNING
NOTE
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
33
TKS500S

Publicidad

Tabla de contenido
loading

Tabla de contenido