HOLZMANN MASCHINEN TKS500S Instrucciones De Servicio página 28

HOLZMANN MASCHINEN GmbH
Assembly base-frame



Assembly saw blade:
Loose two screws M8 (S) on the saw blade cover (1).
 Swivel off the saw blade cover.
 Loosen the clamping nut (M20, left-hand thread).
• Install the saw blade.
NOTE: Use only well sharpened, crack-free and not de-
formed saw blades.
 Tighten clamping nut, with holding wrench (LEFT-
HAND THREAD!!)
 Fold up the saw blade cover and tighten both screws
M8 again.
Assembly riving knife with saw blade protection cover.


NOTE:

•
www.holzmann-maschinen.at
Raise the lower support leg (1).
Mount the short cross support (2), align the
mounting hole (3) and tighten the half-round cap
screws (4) with locking knobs (5).
Then set the machine up
CAUTION
When handling circular saw blades when
changing tools, please use safety gloves
to avoid risk of injury.
Place the already mounted saw blade protection
cover with riving knife from above between guide
plate and clamping plate.
Set the distance between riving knife and saw
blade to 3 - 8 mm (a) and tighten the clamping
plate with four hexagon head screws and wash-
ers (2).
The cover is mounted ready for operation and
must not be removed for operation.
Make sure that the cover always rests on the ta-
ble top with its own weight, but that the two
screws are tightened backlash-free.
ASSEMBLY
28
TKS500S