Storage - Profi Care PC-HSM/R 3100 Manual De Instrucciones

WARNING:
• Do not immerse the power adapter in
water!
CAUTION:
• Also do not clean the appliance under running water! The electronics could get
damaged.
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
• Regular cleaning and maintenance ensures optimum results and long lifetime.
• Use the cleaning brush (8) to remove remaining hair after use. Remove the comb
attachment (6) for this.
• Clean the casing with a slightly damp cloth, if necessary.
• Clean the power adapter (10) only with a dry cloth.
Attach / Remove Clipper Head
The shearing head (3) is screwed to the housing. To remove the shaving head, see
fig. on page 3.
1. Use a Phillips screwdriver to unscrew the 2 screws (11) and remove the shaving
head.
2. Regularly apply 1 – 2 drops of oil (7) to the shaving head.
3. Clean the shaving head with the cleaning brush (8).
4. After cleaning, attach the shaving head to the housing again. To do this, press the
shaving surface against the housing and screw the 2 screws back in so that the
shaving head is firmly seated.
• Clean the appliance as described and allow it to dry.
• Place the cover cap (9) on the shaving head (3) in the same way as a comb
attachment (see chapter entitled "Adjust Cutting Length").
• You can use the hanging loop (5) to hang up the appliance on a hook after
cleaning.
PC-HSMR3100_IM - 01.2022

Storage

79
07.01.22