AEG RCB83826TX Manual De Instrucciones página 11

Problem
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
The compressor does not
start immediately after
pressing the COOLMATIC
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
DEMO appears on the dis-
play.
Possible cause
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC function
is switched on.
The COOLMATIC function
is switched on.
This is normal, no error has
occurred.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent wa-
ter from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The appliance is in demon-
stration mode.
ENGLISH
Solution
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
The compressor starts after
some time.
The compressor starts after
some time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Keep the mode key pressed
for approximately 10 seconds
until a long sound is heard and
display shuts off for a short
time.
11