Parts Identification - Phoenix Contact ASD 21 Manual

All manuals and user guides at all-guides.com

Parts Identification

A Hexagonal Bit Holder (Attaching the bits)
NOTE: When attaching or removing bit, be sure to
set the main switch lock at the lock position.
Bit
9.5 mm – 11.5 mm
(3/8" – 7/16")
Figure 1 Attaching the bits
• Hold the bit holder and pull it against the driver.
• Insert the bit into the hole of the drive shaft.
• The bit holder will return to its original position when re-
leased.
• Pull the bit to make sure it does not come out.
• To remove the bit, pull back on the bit holder in the same
way.
102553_00_ia
Hexagonal bit holder
6,35 mm
(1/4")
PHOENIX CONTACT
23