Fall Arrest - Hilti DX 6 Manual Del Usuario

2. Bring the arrow marks into alignment and insert the exhaust gas piston return unit into the housing.
3. Insert the fastener guide or the magazine centered into the exhaust gas piston return unit.
4. Fit the piston.
5. Position the buffer on the fastener guide or the magazine.
6. Insert the fastener guide or the magazine centered and not tilted into the exhaust gas piston return unit.
7. Turn the fastener guide or the magazine clockwise until it engages.
▶ The fastener guide or the magazine is locked.
5.2

Fall arrest

WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product
as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure.
Check that the carabiner holds securely.
Comply with the operating instructions of the
Hilti tool tether.
5.3 Scaffold hook (accessory)
The Hilti scaffold hook (accessory) can be installed and used for hooking the product to a railing or a tool-
belt for a short time. To install the accessory, follow the installation instructions provided with the accessory.
There is a copy of the installation instructions at the end of these operating instructions.
The fastening tool must additionally be secured with the Hilti tool tether.
6 Operation
WARNING
Risk of injury by accidental triggering! A loaded fastening tool can be made ready to fire at any time.
Accidental triggering can endanger you and others.
▶ Always unload the fastening tool (cartridges and fasteners) whenever you interrupt work with the fastening
tool.
▶ Before all maintenance, cleaning and setup activities, always make sure that there are no cartridges and
no fasteners in the fastening tool.
WARNING
Hazard due to hot surfaces! The fastening tool can become hot in use.
▶ Wear protective gloves.
*2232123*
2232123 English 9