Fall Arrest; Setting The Speed - Hilti NURON GPB 6X-22 Manual De Instrucciones

6. Perform a test run. Run the satin finisher for 30 seconds without load and check for vibration and
imbalance.
▶ If vibration or imbalance is perceptible, remove the tool and reinstall it correctly. Make sure it is
correctly seated. Do not use damaged tools or spacer rings.
5.5 Pneumatic rubber roller
1. If necessary,deflate the pneumatic rubber roller by opening the valve. Use the back of the valve dustcap
for this purpose.
2. If applicable, ease the abrasive belt off the pneumatic rubber roller.
3. Slip a new abrasive belt on to the pneumatic rubber roller. Make sure that the abrasive belt does not
project on either side.
4. Tension the abrasive belt by inflating the pneumatic rubber roller with the air pump provided for the
purpose. Then screw the valve dustcap back on to the valve.
5.6 Adjusting the guard and grip
Always adjust the guard to a position at which the material removed by grinding is directed away from
you.
1. Open the clamping lever for adjusting the grip and the guard.
2. Turn the grip and the guard to the desired position.
3. Close the clamping lever.
5.7

Fall arrest

WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶ The motor runs.
3. Lock the on/off switch.
6.2

Setting the speed

▶ Use the adjusting knob to set the speed.
22 English
3
4
2327537
*2327537*