Trilux twenty3 2310 1200 Serie Instrucciones De Montaje página 3

EN
For your safety
Read all instructions and mounting steps
carefully. Keep the instructions for maintenance
or disassembly work.
Explanation of the warning levels
Observe and follow the warnings.
Non-observance of the warnings may lead
to injuries or material damage!
WARNING! Indicates dangers which
can result in serious and/or fatal
injuries.
CAUTION! Indicates dangers which
can result in injuries or health hazards.
NOTICE. Indicates dangers which
can result in material damage or
malfunctions.
TIP. Indicates information containing
advice or a useful note.
Explanation of important symbols and
pictograms
Indicates professional personnel who
are trained and authorised to carry out
the electrical connection.
Indicates professional personnel who
are trained and authorised to carry
out the mounting.
Safety notes
WARNING! Risk of electric shock!
Never work with voltage applied.
WARNING! Risk of electric shock!
The light source of this luminaire shall
only be replaced by the manufacturer
or a service technician authorised by
the manufacturer or a similar
qualified person. If the light source
malfunctions or fails, please contact
TRILUX.
4 | 28
2310 LED
WARNING! Observe the 5-fold safety
when specifying the on-site mounting
equipment.
NOTICE. For use in environments
D
where an accumulation of conduc-
tive dust on the luminaire may be
expected.
NOTICE. Wear clean installation
gloves to prevent soiling.
Important information on wall mounting
With vertical wall mounting, only
install luminaires without through-wiring.
Important information on electronic control
gear units (ECG)
A neutral conductor interruption in the three-
phase circuit leads to overvoltage damage in the
lighting system. Only open the neutral conduc-
tor isolating terminal in de-energised state, and
close the neutral conductor isolating terminal
before switching on again. Do not exceed the
maximum permissible ambient temperature ta
of the luminaire.
Exceeding this limit reduces the service life
and in extreme cases there is a risk of premature
failure of the luminaire. Design connection
cables for the control inputs of DALI control
gear (1-10 V, DALI etc.) to be 230 V mains volt-
age-proof (basic insulation).
Intended use
Intended for indoor, standard use in damp
rooms and in covered outdoor use with a
maximum ambient temperature of: ta -20 °C
to +25 °C
Safety class: I
Protection rating: IP66
Suitable for further wiring. Max. total current
10 A at 1,5 mm .
2
Suitable for further wiring. Max. total current
16 A at 2,5 mm .
2
With accessories suitable for mains
through-wiring. Max. total current 10 A at 1,5
mm . Max. total current 16 A at 2,5 mm
2
10262936 | 220127 | © trilux.com
2310 LED
Disposal of waste electrical and electronic
equipment
Always collect and dispose of old elec-
trical and electronic equipment sep-
arately at the end of its service life. In
case of doubt, seek information about environ-
mentally-compliant waste disposal from your
local district authority or special waste dis-
posal companies. Current information on the
energy efficiency class of the selected product
version can be found in the corresponding data
sheet for the luminaire. Instructions for replac-
ing or removing the light source in accordance
with Regulation 2019/2020/EU can be found at:
www.trilux.com/EcoDesign
Directive 2014/53/EU
Simplified EU Declaration of Conformity
according to the RED Directive if the luminaire
is equipped with a control gear unit with NFC
interface or a radio component:
TRILUX hereby declares that the following
radio system type complies with Directive
2014/53/EU:
2310 ...
The full text of the EU Declaration of Confor-
mity is available on the Internet at:
www.trilux.com/eu-conformity
.
2
© trilux.com | 220127 | 10262936
EN
5 | 28