Software Updates; Compressor Protection; Auto Changeover - Honeywell Home FocusPRO TH6320WF1005 Serie Guia Del Usuario

Software updates

Honeywell Home periodically issues updates to the software for this thermostat. The
updates occur automatically through your Wi-Fi connection. All your settings are
saved, so you will not need to make any changes after the update occurs.
While the update is taking place, your thermostat screen flashes Updating and shows
the percentage of the update that has occurred. When the update is complete, your
home screen will appear as usual.
Note: If you are not connected to Wi-Fi, you will not get automatic updates.
Adaptive Intelligent Recovery (AIR)
This feature allows the thermostat to "learn" how long the heating/cooling
system takes to reach programmed temperature settings, so the temperature is
reached at the time you set.
For example: Set the Wake time to 6:00 am, and the temperature to 70°. The heat
will come on before 6:00 am, so the temperature is 70° by 6:00 am.
Note: System setting function 13 controls Smart Response Technology. See
"Adaptive Intelligent Recovery (AIR)" on page 10.

Compressor protection

This feature forces the compressor to wait a few minutes before restarting,
to prevent equipment damage.

Auto changeover

This feature is used in climates where both air conditioning and heating are used
on the same day.
When the system is set to Auto, the thermostat automatically selects heating or
cooling depending on the indoor temperature.
Heat and cool settings must be at least 3 degrees apart. The thermostat will
automatically adjust settings to maintain this 3-degree separation.
The message Recovery is
displayed when the system
is activated before a
scheduled time period.
9
M38880
Percentage of
update complete
M38883
M38884
The message Cool On (or
Heat On for a heat pump)
will flash during the wait
time.
M38885