Temperature Setting; Cleaning And Maintenance; Technical Data - camry Premium CR 7722 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
IMPORTANT: The + symbol on the battery inserted should be facing upwards. Firmly close the battery compartment to begin using the
Remote Control (8).
TIMER FUNCTION: The timer function can be used in any mode. The timer allows you to set the length of time from 1-8 hours. To use the
timer, press the timer button (13). Each press of the button increases the time set by 1 hour. The amount of time set will be displayed
on the unit, and will count down in 1 hour. If the timer has been set for 8 hours (MAX amount of time) pressing the button once more
will reset the Timer Function.
OSCILLATION FUNCTION: Press the oscillation button (11) to turn on the oscillation function. The device starts to swing left and right side.
Press the oscillation button (11) again to turn off the oscillation function.
TEMPERATURE SETTING: By pressing buttons (14) and (10) set up desired room temperature.
1.
The temperature range is available in the range from 10 to 49 degrees. Press button (14) to increase the desired temperature and
press button (10) to decrease the desired room temperature.
2.
The device working on full power when the room temperature is 4°C lower than the setting temperature.
3.
The device working on half power when the room temperature is between 0° and 2°C lower than the setting temperature.
4.
The device switches off when the room temperature is higher than the setting temperature. The fan working 30 seconds to make
inside cool to protect components, then fan stops, the device enter into standby.
5.
The device switches on again when the room temperature falls 2°C below the setting temperature.
WARNING: During use, do not touch or cover the air inlet and air outlet.
SAFERTY PROTECTION
1. OVERHEAT PROTECTION: This device is fitted with a safety overheat protection device. If overheating occurs, ensure the power switch
(6) is off and turn off the power supply. Unplug the device and let it cool down for 30 minutes. If something is obstructing grids (4 and
5), ensure the object is removed. After 30 minutes has passed, turn the device on again as described above.
2. TIP-OVER SWITCH: The device will only work on a firm stable surface. If the device is not 100% stable, vertical position, the unit will
switch off until placed in the correct position.

CLEANING AND MAINTENANCE

1. Make sure the device is not hot.
2. Before cleaning the device remove the plug from the electrical socket.
3. Keep the air inlet (5) and outlet (6) openings clean. Do not allow dust to collect on the openings. To clean the air filter:
Remove the air inlet grid on the back of device. Located behind the inlet grid is dust mesh filter, remove it and rinse under clean running
water. Do not use any detergents or solvents to clean the filter. Leave to dry completely for 24-48 hours before re-installing into the
device. Do not attempt to use a wet/damp filter as this could damage the device.
4. Clean the housing using only dry or moist cloth.
5. Do not immerse the device in water!

TECHNICAL DATA

Voltage: 220-240V ~50Hz
Power: 2200W
Battery: 1 x CR2025 (3V) lithium battery included
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance
should be delivered to the dedicated collecting points due to hazarsous components, which may effect the environment. Do not dispose this
appliance in the common waste bin.
ALLGEMEINE SICHERHEITSVORSCHRIFTEN LESEN SIE AUFMERKSAM WICHTIGE
ANWEISUNGEN BEZÜGLICH DER SICHERHEIT DER BENUTZUNG BEWAHREN SIE
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
geändert.
1.Vor dem ersten Gebrauch, die Bedienungsanleitung lesen und die dort angegebenen
Hinweise beachten. Der Produzent trägt keine Verantwortung für Schäden, die aufgrund
von bestimmungswidriger Nutzung oder unsachgemäßer Bedienung entstanden sind.
2.Das Gerät ist nur für den Hausgebrauch verwendet. Verwenden Sie es nicht für andere
Zwecke als den bestimmungsgemäßen Gebrauch.
3.Das Gerät ausschließlich an die Steckdose 220-240V ~50Hz anschließen. Es darf nicht
zu anderen, bestimmungswidrigen Zwecken benutzt werden. Wegen
Vorsichtsmaßnahmen, sollten keine weiteren Geräte an den gleichen Stromkreis
angeschlossen werden.
4.Falls sich Kinder in der Nähe befinden, sollte bei der Nutzung des Gerätes spezielle
Vorsicht bewahrt werden. Dieses Gerät ist nicht zum Spielen für Kinder, sowie für
Erwachsene, die sich mit der Bedienungsanleitung nicht vertraut gemacht haben,
geeignet.
DEUTSCH
DIESE FÜR DIE ZUKUNFT AUF
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cr 7722

Tabla de contenido