Getting Started; Charging The Battery - W'eau EV75 Manual De Usuario

GETTING STARTED

Charging the battery

IMPORTANT NOTE: Fully charge the pool vacuum (about 6 hrs) before
using it for the first time.
WARNING!
 Use only the original external adaptor and charging plug provided.
 Make sure the pool vacuum and the charging port are clean and dry
before set-up and charging. (TIPS : use a cotton bud to dry the charging
port and charging pins)
 Charging must be done indoors, in a well-ventilated area away from
sunlight, children, heat, ignition sources, and with an ambient
temperature between 5˚C (41˚F) and 35˚C (95˚F).
 Never use the external adaptor and charging plug if any damage is
detected.
 The charging pins are waterproof. However, remnants of water in the
port and around the pins could result in natural occurrence of stains (a
byproduct of chemical reaction between water and electric currents).
Otherwise, the stains can be removed by light scrubbing with a cotton
bud soaked with juice of lemon or vinegar.
 Make sure that the pool vacuum is turned off prior to charging.
1. Place the unit on a flat surface. Set the pool vacuum to Power
Off/Charging Mode by turning the switching knob anticlockwise until it
clicks and completely exposes the charging port.
2. Align and insert the charging plug to the charging port.
WARNING! Be sure not to invert the charging plug and ensure both the
charging plug and charging port are clean and dry before charging them.
TIPS: Use cotton bud to dry the charging port and pins. Plug the charging
cable of the external adaptor into the charging plug.
10